Premier designs WindGarden 26829 User manual

Dune Buggy Spinner
assembly
instructions
Step 3
Remove your Dune Buggy Spinner from the package. The Strut Assembly is shipped in three sections. Open the Velcro seam along the
bottom of the Dune Buggy. Connect the Rod of the Front Strut Assembly to the Star Lock Hub of the Internal Rear Strut Assembly.
(Diagram A)
Step 2
Slide the narrow, plastic tipped end of the Support Pole into Star Lock Hub. Push down on the hub until The Support Pole locks into place
and cannot be removed. Close Velcro Seam. (Diagram B)
Completed Internal Strut Assembly.
Make sure all parts connect as shown.
sku #26829
B
Body Sleeve Body Sleeve
A
Rear Strut Assembly
(Internal Body
Struts)
Velcro
Seam
Front Strut Assembly
will have to be
connected to
Internal Body Struts
Plastic Tip of Support Pole
Support Pole
Push Star Lock Hub rmly
onto Plastic Tip of Support Pole
NOTE: To make insertion process
easier, place bottom of Support Pole
on a hard, at surface and push
down on Star Lock Hub.
Star Lock Hub
Star Lock Hub

D
C
PLEASE NOTE: Although your Dune Buggy Spinner is constructed with UV resistant SunTexTM fabric, it is recommended that you take it inside
during storms and harsh weather to preserve its durability.
E
Support
Pole
Ground
Stake
ferrule
Step 3
Slide the Spinner Axles onto the Wheel Strut Assemblies. Tighten knobs on the "T"
Joints to hold the Axles to the Struts. (Diagram C)
Step 4
Take one of the four Spinner Wheels and slide it onto the Spinner Axle. Slide second
Spinner Wheel onto Spinner Axle. (Note: Spinner Wheels on same axle should
spin in opposite directions. Before putting second Axle Cap into place, make
sure wheels spin as shown in diagrams C and D.) Pound Axle Caps onto uncapped
ends of Spinner Axle using a mallet or piece of wood. (Diagram D)
Step 5
Repeat Step 4 using second Spinner Axle and the two remaining Spinner Wheels to
assemble the front Spinner.
Step 6
Drive Ground Stake into ground and insert the non-ferruled end of the Lower
Support Pole into the Ground Stake . Insert Upper Pole of assembled Dune Buggy
Spinner into the ferrule. (Diagram E)
Dune Buggy Body
Dune Buggy Body
Spinner
Axle "T" Joint
First, slide Spinner
Axle onto
Strut Assembly
Second, tighten
knob on "T" Joint
Spinner
Wheel
Wheels on
same axle
should spin
in opposite
directions
Axle Cap
Slide Spinner
Wheels onto Spinner
Axle, then hammer
Axle Cap onto end