arcelik 3340 SJ User manual

Dear Customer,
We wish that this product, manufactured at modern facilities with total quality notions, will deliver
you the best performance. In order to guarantee this, please read this instruction manual
thoroughly and keep it for your future reference.

Part 3:
Preparation
Part 4:
Program selection and washing operations.
Part 2:
Steps before operating Fullautomatic Washing Machine and safety precautions.
Part 7:
Helpful tips on stain removal
Part 1:
Technical features.
Part 5:
Care and Maintanence.
Part 8:
Before calling service.
CONTENTS
Part 6:
Determining location and installation
1

Front door
Top lid
Technical features
Part 1:
Kick plate
Kick plate cover
Control panel
Capacity (dry fabric)
Height
Width
Depth
Net weight
Power requirement
Nominal current
Power
Washing speed
Spin speed
3340 SJ
4120 SJ
3650SJ
3800SJ
4450SJ
4900 SJS
7 kg.
85 cm.
60 cm.
59 cm.
71 kg.
220 V, 50 Hz.
10 A.
2100 Watts.
52 rpm.
800 rpm.
800 rpm.
1000 rpm.
1200 rpm.
1000 rpm.
1200 rpm.
2
The appearance and specifications are subject
to change without notice to raise the unit
quality.
The graphics shown in the manual are
schematic and it is possible that they not
conform with your washing machine.

The current requirement in order for safe operation of this machine is 16 Ampheres. You will need to have a certified
electrician to connect a 16 Amp fuse, if there is not enough current load.
Your washing machine is set to 230 Volts.
Do not forget to check the grounding in all cases of use with or without the transformer. Our company will not be responsible
for any damages caused by operations without grounding.
In order to bring the machine to ready before use, please call your service technician or a certified plummer.
The performance of the washing machine depends on the effectiveness of the cleaning agent. Stains can be permanent if
low quality detergents are used. Please take necessary effort to clean the stained clothes as described in following pages
before washing them in the machine.
Your washing machine is designed only for domestic use.
If the power cord or the plug is damaged, please call a certified technician.
Always use new “water inlet hose” received within your machine.
Please perform the first wash with detergent, at COTTON 90 program and without placing your laundry inside the washing
machine. This will ensure that the drum is free from any left over dirt from production .
Due to the quality control processes during production, there may be some water left over in your machine.
This does not cause any damage to your product.
3
Steps before operating Fullautomatic
Washing Machine and safety precautions.
Part 2:

To open the front door
Sort the laundry according to the following groups and wash them seperately:
- white and resistant colored fabrics,
- colored fabrics,
- delicate fabrics (silk, rayon etc.),
- wool.
Be sure to empty pockets and remove any belts, buttons, pins, etc. from the clothing. You can place little clothing materials
(baby socks, etc) inside of pillow cases to avoid them slip into the pump and filter. For stained fabrics, refer to the “Practical
information” section of the operating manual.
Sorting laundry
press the “door open button. For your safety, front door can
be opened only when the machine is off.
Part 3:
Preparation
Attention! Before any operation of the machine check the following.
Did you close the front door?
Is the tap open?
Is water drain hose placed properly?
Is power connected?
Loading the machine
Place the fabrics uniformly inside the machine. Hand knits should be placed inside out in the machine. Make sure that there is
no clothing at the side of the door. Close the door by pushing lightly. If the door does not close completely, the machine could
not be started-a safety measure. Front door is locked untill the end of the washing program and it will not be opened about 2
minutes following the end of the program. 4

Choose the appropirate detergent specifically used at the full automatic washing machines. Suggested amount is given on the
detergent cover.
Do not attempt to use detergents and bleaching elements that contain chlor and sulphur. The amount of the detergent depends
on the dirt level of fabric, the amount of fabric and the softness of the water.
Detergent and softener selection
a. Compartment I. detergent compartment for prewash
cycle.
b. Compartment II. detergent compartment for wash cycle.
c. " " Compartment for fabric conditioner.
d. Siphon.
5
Detergent Dispenser
Attention! Fill the softener according to the supplier recommendation (app. <100 ml).
Do not exceed the “MAX level” marked on the detergent dispenser.
WARNING!
When the CURTAIN program is selected Pre-wash
function is automatically set. Pre-wash can be
operated even without detergent.

Control Panel
Quick wash
Detergent drawer
Anti Creasing
Program follower
Prewash
Spin speed selection
Remain time
Timedelay adjustment button
Start/Pause/Cancel button
Door open button
On/Off Button
Rinse Plus
Program selection knob
6

Spin Speed Selection
Using this button, you can select final spin speed upto 1200/1000/800 rpm. If you do not
want to apply spinning to your clothes, select “ ” option.
Rinse Hold
If you desire to leave your synthetic and wool fabrics in the machine after the wash program
you may select the Rinse hold option to prevent them getting wrinkled. If you want to cancel
the “Rinse Hold” function, you have to press on “Start/Pause/Cancel” button first, select the
desired spin speed and then repress on the “Start/Pause/Cancel” button.
3800 FD
4900 FDS 3650 FD
4450 FD
Functions
Anti Creasing
To avoid wrinkling of your clothes, select this function. When Anti-Creasing is choosen please load less cloth, this way a special washing
and spinning profile will reduce the wrinkles and your clothes will be easy to iron.
Rinse plus
By using this function your machine will add another rinse process to the three rinse processes that it has already done. This
additional rinse will reduce any affects on sensitive skin by washing leftover detergent.
Quick wash
Shortens washing time for lightly soiled fabrics. This function can be used for cotton and synthetic programs for temperatures below 60° C.
7