Arcora International M5 PLUS User manual

OPERATION MANUAL
Marsstraße 9 ● 85609 Aschheim near Munich - Germany
Tel.: +49(0)89 - 14 33 29 30 ● Fax: +49(0)89 - 14 33 29 329

You probably want to get to know your new hoover as quickly as possible and be able to operate
it safely. Please read these instructions for use before you start using the appliance.
To avoid accidents and damage, start with the chapter >>Safety instructions<< and be sure to
observe the instructions listed here.
Dear customers
Content
Description of the vacuum cleaner
Operating elements
Handling
Safety instructions
Section
Section
Section
Section

Section 1 Description of the vacuum cleaner
The M5PLUS vacuum cleaner can be used as a dry vacuum cleaner for cleaning large areas in offices, hotels,
restaurants, doctors' practices, shops. The vacuum cleaner can be used to clean hard floors (stone, parquet, plastic)
as well as soft floors (carpets, upholstered furniture, curtains). The robust and modern construction guarantees a
long service life and convenient operation with low usage costs.
Technical Details
Power supply:
Power cable:
Max. capacity:
Vacuum:
Features: Protective insulated (class II),
interference-suppressed, CE-sign

Section 2 Operating elements
Slide control of the
suction power
Metal plug tube
Upholstery nozzle
Crevice nozzle
Brush nozzle
Fleece filter bag
Floor nozzle

Section 2
The flexible suction hose with rotating end pieces facilitates the
operation of the accessories. The bleed valve is on the handle of
the suction hose.
With the slider of the valve you can adjust the suction power,
especially recommended for curtain cleaning.
Connect the metal tube with the handle of the suction hose and
the accessory to the pipe.
Upholstery nozzle
With the upholstery nozzle
you can dust off upholstered
furniture, mattresses, pillows,
curtains, etc.
Brush nozzle
The brush nozzle is suitable
for extracting uneven
surfaces, such as profile
strips.
Crevice nozzle
The crevice nozzle is suitable
for the suction of wrinkles,
joints and corners or niches
that you can’t reach with the
floor nozzle.
Operating elements

Section 2
The floor nozzle is the most commonly used element of the
accessory. It is suitable for large flat surfaces such as carpets or
floors. For vacuuming smooth
floors such as PVC, parquet or
stone, the floor nozzle is
additionally equipped with a brush.
If necessary, press your foot on the
rocker arm to extend or lower the
brush. Carpets and carpets should
be vacuumed without a brush. To
do this, push the toggle switch forwards.
Floor nozzle
Fleece filter bag
The extremely tear-resistant fleece filter bags offer a high
degree of dust retention and, compared to paper filter bags,
allow significantly longer vacuuming cycles.
Attention: To insert or replace
the bag you must first pull out
the suction hose.
Operating elements

Section 3 Handling
Switch button
Housing
Connection
opening for the
suction hose
Locking lever

Section 3
Before switch on the vacuum cleaner:
♦ Please make sure that the fleece filter bag is correctly
inserted in the housing inlet. Do not use the vacuum
cleaner if no dust bag is inserted.
♦ Insert the suction hose into the connection opening and
turn it slightly to the right or to the left to lock.
♦ Insert metal pipes into each other and put them together
with the handle of the hose. Place the necessary nozzle
on the lower end of the suction pipe.
♦ Plug the power plug into the socket.
♦ Press the switch button to switch on the device.
After vacuum
Once cleaning is complete, turn off the power.
To switch off, tap on switch button.
Disconnect the power plug from the socket.
Replacing the dust bag
. ♦ Turn off the vacuum cleaner and pull out the plug
. ♦ Remove the suction hose from the device
♦ Unlock the dust bag chamber with the cover lever,
remove the cover.
♦ Grasp the dust bag and pull it out.
♦ Insert a new dust bag into the dust bag chamber.
♦ Close the lid again, check before commissioning
whether all components are properly installed.
Handling

Section 3
Replacing the foam and motor protection filter.
From time to time, the foam and motor protection filters
must be changed. In the event of visible contamination, you
can clean them by rinsing in lukewarm water with a little
detergent and after complete drying, replace the cover.
HEPA-Filter
♦ Remove three screws in the lid, take off the lid and
remove the foam filter.
♦ Insert a new or cleaned filter.
♦ Put the lid on and tighten the screws.
Unscrew the
the screws Remove
the lid
Foam filter
Handling

Section 3
Motor protection filter
♦ Turn off the vacuum cleaner.
♦ Remove the lid.
♦ Remove the motor protection filter from the motor cover.
♦ Insert a new or cleaned motor protection filter.
Lid insert
Motor protection filter
Screws
Lid insert
Motor protection
filter
Handling

Section 4 Safety instructions
Safety instructions
Please note that improper handling of electrical
appliances may present hazards that may not be
detected by children. Have children work with the
device only under the supervision of an adult.
Repairs to electrical appliances may only be carried
out by authorized specialists. If the power cord of this
equipment is damaged, it must be replaced by the
manufacturer or service center or a similarly qualified
person to avoid hazards. Improper repairs can result
in serious danger to the user. In case of self-made
repairs, improper connection or incorrect operation
liability and warranty claims are excluded.
♦
♦
The vacuum cleaner may only be used with the
fleece filter bags and filters approved for this
machine. Only then is the perfect suction
guaranteed. Used or damaged dust bags must not
be reused.
Never leave the appliance in damp rooms after use.
Never vacuum up water or other liquids or wet dirt.
Do not vacuum glowing ashes, burning cigarettes
or sharp objects, glass splinters, plaster, cement or
stone dust with the vacuum cleaner.
Disconnect the device from the power supply when
cleaning it, change the dust bag or filter or leave it
unattended.
♦
♦
♦
♦