User’s Manual –AREBOS Axle stand 3 t
4
•Use only as specified by the manufacturer.
•No alterations or modifications shall be made to this product.
•Ensure the load does not exceed the maximum capacity as marked on the axle stand,
per pair.
•Use no more than a single pair of stands either on the front, rear or one side of the
vehicle. Use in pairs.
•Use on a hard, level surface, e.g., concrete. Do not use on uneven ground or
tarmacadam.
•Securely chock wheels in contact with the ground. Before jacking and placing the
stands, apply vehicle handbrake (put automatics in ‘Park’).
•Make sure that each stand is securely located under a strong point on the vehicle;
consult the vehicle manufacturer’s handbook for guidance. Ensure that height adjust
locking mechanism is fully located before applying any load to the axle stand.
•Ensure that the load is located centrally on the saddle, and that the weight is directed
through the vertical axis of the stand.
•Exercise extra care when using with a three wheeled vehicle or a trailer. Refer to
vehicle manufacturer’s instructions.
•Once vehicle is supported, ensure that the vehicle and stands are stable before
starting work. Ensure that it is not possible for the vehicle to move before
commencing any work.
•Before commencing any work or going beneath the vehicle, undertake a risk
assessment. Ensure that a responsible person is aware of the work about to be
undertaken.
•Inspect stands before each use. DO NOT use if they show signs of damage. DO NOT
use if it is suspected that they have been overloaded.
•DO NOT use axle stands on the highway, or anywhere else if it is deemed to be
unsafe.
•DO NOT push or twist the vehicle/load whilst it is supported on stands.
•DO NOT mix components between stands. Use only as supplied.
•DO NOT allow children or animals in the vicinity of a vehicle supported on axle
stands.
•DO NOT leave a vehicle on axle stands in an area that could be considered a hazard to
others or property.
