argon audio WRT User manual

w w w . a r g o n a u d i o . c o m
WRT Quick start
Safety
Safety Instructions
Unplug this product from the wall outlet before cleaning. Do not use this
product near water or moisture. Do not spill liquids on the product. Clean only
with a dry cloth.
•Place the unit on a solid surface.
•Do not put it in a closed bookcase or a cabinet that may keep air from
flowing through its ventilation openings.
•Do not install near any heat sources, such as radiators, heat registers,
stoves or other appliances that produce heat.
•Protect the power cord from being walked on or pinched, particularly at
plugs and the point where they exit from the product.
•During Lightning storms, unplug the product from the power source or
if unused for long periods of time. This will prevent lightning and
power-line surge damage to the product.
•Do not attempt to service this product yourself. Opening or removing
covers may expose you to dangerous voltages or other hazards. Please
contact the manufacturer to be referred to an authorized service center
near you.
•Do not overload wall outlets, extension cords, or integral power circuits
as this can result in a risk of fire or electric shock.
•Never push any object through the product openings, as this can result
in fire, electric shock or damage.
•Use proper power sources. Plug the product into a proper power
source, as described in the operating instructions or as marked on the
product.
If there is a Lightning flash with an arrow head
on the product, it’s intended to alert the User
of the presence of un-insulated “dangerous
voltage” within the product, that might be of
sufficient magnitude to constitute a risk of
electric shock to persons.
If there is an Exclamation point on the
product, it’s intended to alert the User that
there is important operating and maintenance
(servicing) information in the User manual.
If there is a double rectangular symbol on the
product, it means that the product is double
insulated. Earth connection is not required.
Included in the box
1 x Wireless Transmitter
1 x Wireless Receiver
2 x 3.5 mm minijack to single RCA cable
2 x 3.5 mm minijack to dual RCA cable
2 x Power supplies with power cables

w w w . a r g o n a u d i o . c o m
WRT Quick start
About Argon Audio WRT
This wireless kit supports the full audible frequency band,
meaning it can be used to wirelessly transfer the sound
from your turntable, streamer, CD-player etc. to your
amplifier or active speakers. Another use could be to
make a subwoofer wireless.
The wireless transfer introduces a 25-millisecond delay–
please adjust your equipment. Accordingly if possible.
Quick start
1. Connect the Wireless Transmitter to your source of
choice. For example the subwoofer output on your
amplifier.
2. Connect the Wireless Receiver to the equipment you want
to receive the sound. For example the input on your
subwoofer.
3. Connect both the Transmitter and Receiver to power.
4. The Transmitter and Receiver will pair automatically. A
blue light on both units will signify a successful pairing.
Troubleshooting
Pairing failed
The light on the units will flash if pairing fails. To re-pair, try
these steps:
1. Press and hold the button on one of the units. The blue
light will start flashing to indicate pairing mode.
2. While the light is flashing on one unit, quickly press and
hold the button on the other unit to enter it into pairing
mode too.
3. Both units will now blink to indicate that they have been
paired.
4. If this does not work, try bringing the units closer
together.
Sound is distorted or drops out
The maximum range of the wireless signal is around 12
meters/40 feet. If the signal drops out or distorts, bring the
units closer together, and make sure they have line of sight,
with as few objects/walls between them.
Also make sure other wireless devices, such as routers, are not
placed too close to either units.