Aries 3500300 User manual

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •3500300-INS-RA •PAGE 1
INSTALLATION MANUAL 3500300
Parts List
1Driver / left mirror bracket
1Passenger / right mirror bracket
1Backer plate
2Mirror
4Hex nut, 5/16"
4Washer, lock, 5/16"
8Washer, flat, 5/16"
4Screw, button head, 5/16"
2Screw, button head, 1/4"
2Nut, hex, 1/4"
2Washer, lock, 1/4"
2Washer, flat, 1/4"
Tools Required
Ratchet Socket set
Torque wrench Allen wrench set
Maintenance
To protect the product, wax after installing. Regular waxing is recommended
to add a protective layer over the finish. Do not use any type of polish or wax
that may contain abrasives that could damage the finish.
For polished, gloss and other smooth finishes,
polish may be used to clear small scratches and scuffs on the finish.
Mild automotive detergent may be used to clean the product. Do not use dish detergent, abrasive
cleaners, abrasive pads, wire brushes or other similar products that may damage the finish.
Product Photo
Torque Specifications
1/4" bolt 75 in-lbs.
5/16" bolt 132 in-lbs.
Use above torque setting unless otherwise noted
Level of Difficulty
Easy
NOTICE
Before you begin installation, read all instructions thoroughly.
Proper tools will improve the quality of installation and reduce the time required.
To help prevent damage to the product or vehicle, refer to the specified
torque specifications when securing hardware during the installation process.
Product Registration and Warranty
CURT Group stands behind our products with industry-leading warranties.
Provide feedback and help us to improve our products by registering your purchase at:
warranty.curtgroup.com/surveys

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •3500300-INS-RA •PAGE 2
Step 1
Starting on the driver side, locate the
mounting locations on the tube door.
Step 2
Locate the driver-side mirror bracket and
backer plate. Secure the mirror bracket and
backer plate to the tube door using two 5/16"
screws, four 5/16" flat washers, two
5/16" lock washers, and two 5/16" nuts.
Repeat steps 1 and 2
on the passenger side.
Step 3
Finish securing the backer plate using a
1/4" screw, flat washer, lock washer and nut.
Repeat Step 3 on
the passenger side.

ARIESAUTOMOTIVE.COM •NEED ASSISTANCE? •8 7 7. 2 8 7. 8 6 3 4 •3500300-INS-RA •PAGE 3
Step 4
Using the hardware supplied with
the mirrors, fasten the mirrors to
the mirror mounting brackets.
Congratulations on the installation of
your new ARIES Jeep tube door mirrors.
With the mirrors installed, periodic
inspections should be performed to ensure
all mounting hardware remains tight.
To protect your investment, see the
'Notes and Maintenance' section on
the first page of this instruction manual.