4
connected to the audio outputs (Left and Right) present on a TV set,
Hi-Fi system, VCR or radio-cassette player, or to a
headphones/earphones output using the connector supplied.
The red Auto On indicator light will light up as soon as you have connected
the power adapter to the mains outlet and the audio cable to a signal source.
If the Auto On indicator light remains off, switch on the audio source and
increase its output level until the red indicator light comes on.
RECEIVER HEADPHONES
1. Remove the ear cushion holder on the receiver headphones. You will
find a battery compartment right there under the holder.
2. Insert a rechargeable HR03/AAA size batteries at both right / left
earphone, taking care to ensure correct polarity.
3. Close the battery compartment cover and also put back the ear
cushion holder.
OPERATION
1. Switch on the sound source (TV set or audio component) that the
transmitter is connected to.
2. Place the headphones On/Off switch in the On position.
3. Place the headphones on your head and adjust the volume to obtain
the desired sound level.
4. If you cannot find the best reception frequency, press the "Auto Scan"
button on the headphones. The corresponding indicator light will come
on.
5
NOTE:
You should then be able to move around freely from one room to another
without any interference. If interference does occur (interruptions in the
signal), press the "Auto Scan" button once to find a better reception channel.
A For better stereo reception, stay approximately seven meters away
from the transmitter when you press the "Auto Scan" button.
B If it is impossible to find a satisfactory frequency, change the setting on
your transmitter, then press the "Auto Scan" button on the headphones
to find the corresponding channel.
To both protect the transmitter and save power, the transmitter automatically
switches off after approximately four minutes if the signal that it receives
from the audio source is too weak for proper reception. If however the signal
returns to an acceptable level, then the transmitter automatically switches
back on.
CHARGING THE BATTERIES
1. Place the On/Off switch on the receiver headphones in the Off position.
2. To recharge the headphone batteries, place the headphones on the
transmitter, taking care to ensure that the charge contacts touch the
transmitter's charge prongs.
3. The charge process starts automatically and the green indicator light
comes on. Be sure to charge new batteries for 24 hours before using
them for the first time in the headphones.
