Aspen Evolution EFD 1000 FDF User manual

Aspen Evolution EFD 1000 PFD Quick Guide
Airspeed Bug
(set with Left Knob) Altitude Bug
(set with Right Knob)
Heading Bug
(set with Right Knob)
Blank –not enabled in
our airplane
Minimums –On/Off
Press to enable setting
MIN with Right Knob
360/Arc View toggle
Press to enable setting
Barometric Pressure
With Right Knob
Menu (see reverse)
Range +/-
Pressing and holding either the RNG (+) or
(-) Button will cause the map range to scale
continuously to its maximum or minimum
range, respectively
Reversion & Power
Minimum
(set with Right Knob)
Left Knob
(Rotate 1 click or Push to Cycle)
IAS
CRS (default)
CDI Nav Source
(Push to Cycle)
GPS1/VLOC1
VLOC2
Single Line Bearing Pointer Source
(Push to Cycle)
Off
GPS1/VLOC1 (ref 480 CDI selection)
VLOC2
Skid & Slip Indicator
Rate of Turn Indicator
Std Rate
(thick outside
tick mark)
½ Std Rate
(thin outside
tick mark)
Vertical
Speed
Indicator
Speed Markers Displayed here
Vx,Vy,Vne,Va,Vle,Vs,Vso,etc.
GPSS Steering On/Off
Note: Autopilot must be
in HDG Mode. When
GPSS enabled, HDG
value is replaced with
GPSS1 and Autopilot
tracks GPS track. When
disabled, autopilot tracks
HDG.
Note: If GPS from GNS 480 is
selected and pilot changes the CDI on
the 480 from GPS to VLOC, then the
Aspen will also change to VLOC
automatically
Double Line Bearing Pointer Source
(Push to Cycle)
Off
GPS1/VLOC1 (ref 480 CDI selection)
VLOC2
Glide Slope Vertical Deviation Indicator
(hollow diamond when off scale)
ILS Horizontal Deviation Indicator
(hollow diamond when off scale)
Right Knob
(Rotate 1 click or Push to Cycle)
ALT
MIN
BARO
HDG (default)
Altitude Alert
Douglas Fortnam CFII, Version 5

Right Knob
Default after 10 seconds: HDG
SYNC Action
Manual Action
Press to cycle
through:
Press and Hold for >1
second
Active Mode = Magenta
Inactive Mode = Cyan
ALT
Alt Bug and Alerter set to
current altitude
Rotate knob to desired setting
MIN
Sets MIN to the current
altitude
BARO
Sets baro to 29.92
HDG
Sets HDG Bug to the
current heading
Left Knob
Default after 10 seconds: CRS
SYNC Action
Manual Action
Press to cycle
through:
Press and Hold for >1 second
Active Mode = Magenta
Inactive Mode = Cyan
IAS
Sets Airspeed bug to current indicated airspeed
Rotate knob to desired setting
CRS
VOR Nav
Course Pointer points to the VOR
ILS Nav
Current heading
GPS
Course Pointer points to the active GPS
waypoint
GPS
AUTOCRS
Enabled
No effect (always set to desired track
in AUTOCRS mode)
No effect (always set to desired
track in AUTOCRS mode)
Display Brightness:
Push Menu Button then press Left
Knob to toggle between:
Automatic –BRT AUTO
Manual –BRT ADJUST –rotate knob
to desired brightness
Menu Button:
General Settings A
Display Airspeed and Altitude Tapes
Radio Altitude
Auto Course Select
ARC Compass Mode
AHRS Reset
General Settings B
Barometric Pressure Setting UOM
Outside Air Temperature UOM
Not applicable
Not applicable
Auto Range
General Settings C
MACH Display
Altitude
Speed
Overspeed Warning Test
360oMap Settings
360oDeclutter Level
360oFlight Plan
360oAirports
360oVOR’s (High, Low, and Terminal)
360oIntersections / NDB
ARC Amp Settings
ARC Declutter level
ARC Flight Paln
ARC Airports
ARC VOR’s (High, Low, and Terminal)
ARC Intersections / NDB
Menu Button:
V Speeds A
V Speeds
Va
Vbg
Vref
Vr
V Speeds B
Vx
Vy
Vlo
Vle
Power Settings
Check or Switch to Battery Power
Check or Switch to External Power
Restart
External Power Source Voltage
Battery Status
System Status
Main App. Processor Software Version
IO Processor Software Version
Unit Serial Number
Other Menu functions
Push Menu Button, Navigation Mode
(SEL PAGE) is displayed. Rotate
Right Knob to navigate throuh menu
pages. Push Menu Key adjacent to
Menu, use Right Knob to change
value.
Press Menu Button to exit.