AT&T ANC200 User manual

ANC200
User’s Manual
Noise Canceling Wireless Stereo Headphones

Page 2
Welcome
Thank you for purchasing the ANC200
Noise Canceling Wireless Stereo Headphones
Features
- Wireless 5.0 technology with amazing sound
- Built-inmicrophone with echo cancellation
- Full controls for playback and calls
- 3.5 mm auxiliary input jack
- Professional Active Noise Cancelling (ANC) Technology.

Page 3
Micro USB Cable Audio Cord
ANC Wireless Headphones
Unpack the ANC200 wireless headphones and make sure
all accessoriesare put aside so they will not belost.
What’s Included

Page 4
Contents
Introduction
Features 2
What’s Included 3
Safety Information
Important Safety Instructions 5
Getting Started
Location of Main Unit Controls 6
Operational Instructions
Charging 7
Power ON/OFF 7
Pairing 7
Making PhoneCalls 8
8
Listening to Music
Use the ANC function
9
LED Indicator Chart
Troubleshooting10
Compliance with FCC Regulations11
Warranty Information
Limited Warranty 12
14
Memo15

Page 5
Please read all safety and operating instructions carefully
before installationand use, and keep these instructions
handy for future reference. Take special noteof all
warnings listed in this user’s manual and on theANC200.
1. Attachments- Do not use attachments not recommended
by the manufacturer.
2. Water and Moisture - The unit should not be used near
water. For example: near a bathtub, washbowl, kitchen sink,
laundry tub, swimming pool or in a wet basement.
3. Objects and Liquid Entry - Care should be taken so that
external objects do not fall into and liquids are not spilled
onto any openings or vents located on the product.
4. Power Source - The unit should be connected only to
a power supply of the type described in the operating
instructions or as marked on the unit. If you are not sure,
please consult the dealer or local power company.
5. Heat - The unit should be situated away from heat sources
such as radiators, heat registers, stoves or other appliances
6. Servicing- The user should not attempt to service the unit
beyond those methods described in the user’s manual.
Opening or removing covers will expose you to dangerous
voltage and other hazards. Service methods not covered
personnel.
Safety Information
Important Safety Instructions

Page 6
Getting Started
Location of Main Unit Controls
MIC
Power ON / OFF
Volume + /
Next track
ANC Turn ON/OFF
Pause / Play
Volume - /
Previous track
LED indicator light
Micro USB port
Aux in port
Answer / End

Page 7
Operational Instructions
Charge your ANC200 through any USB jack or wall charger.
The LED indicator will glow red when charging. Before
using for the first time, charge at least 4 hours. Aer the
first charge, the headset Will charge in 2 to 3 hours and the
LED indicator Will turn off when the charge is complete
Charging
Press and hold the ON/OFF button for 2-3 seconds to
powered on. Press and hold the ON/OFF button for 3
Power ON/OFF
2-3 seconds to start pairing mode. Once the headset isin
‘ANC200’ among discovered Bluetooth devices on theph-
one to Pair.
Note: If the headset is not paired with a Bluetooth device in 5 minutes, it will turn
itself off.
Pairing

Page 8
Operational Instructions
Making a call
Once paired, use your mobiledevice to dial a number as
usual. Once connected, the call will beheard on your
ANC200 headset.
Answer a call
When receiving a call, press the “ ” button to answer
the call.
Ending a call
While talking on thephone, press the“ ” button
to end the call.
Making Phone Calls
LED Indicator Chart
Status Indicator
Powering ON
Powering OFF
ANC function turn ON
Low battery Blinking red & headset emits a beep
ChargingSolid red light
Solid green light
ANC function turn OFF The green light turn off
Pairing mode
Connection complete Blue light blinks every 3 seconds
Playing musicBlinking blue light

Press the “M” button once , ANC function turn on .The LED
Indicator will solid green light Press “M” button again to
turn off the ANC function and green light is turn off.
Page 9
Operational Instructions
Play/Pause
Press the “ ” button to launch thephone’s music player
and to start listening to music. Whilelistening to music,
press the “ ” button to pause or to resume play.
Song selection
While music is playing, pressthe |+|or |-|buttons to skip
or go to previous songs.
Answer a call while listening to music
When receiving a call, press the “M” button to answer the
call.Press the “M” button whileon the phone to end the call.
When receiving a call, press and hold the “M” button to reject
the call. (Music will resume playing when the call is rejected.)
Volume control
Press and hold Volume
|+|and Volume |-|buttons to
adjust the volume level.
Listening to Music
Use the ANC function

Page 10
Troubleshooting
Symptom Solution
Music is not streaming over
Bluetooth®
Check to make sure both
devices are paired and
connected over Bluetooth.
Restart the headphone to auto-
connect with your Bluetooth
device.
No power Make sure the ANC200 is fully
charged.
Headphone does not answer
phone calls
Check to make sure both
devices are paired and
connected over Bluetooth.
Restart the ANC200 to auto-
connect with your Bluetooth
device.
Music does not resume Press play to resume music.

Page 11
Compliance with FCC Regulations
Caution!
theparty responsible for compliance could void the user’s authority to operate
theequipment.
The equipment has been tested and found to comply with the limits for a Class
B digitaldevice, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate Radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to Radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. Ifthis equipment does cause harmful interference to Radio or
on, the user is encouraged to try to correct the interference by oneor more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increasethe separation between theequipment and receiver.
-
receiver is connected.
-Consult the dealer or an experienced Radio/television technician for assistance.
This equipment complies with FCC’sRF radiation exposure limits set forthfor anuncontrolled
environment. The antenna(s) used for this transmitter must be installed and operated to provide a
separation distance of at least 5mmfrom all persons and must not be collocated or operatingin
conjunction with any other antenna or transmitter.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. THE SPECIFICATION AND EXTERNAL APPEARANCE OF THE HEADPHONES ARE
SUBJECT TO CHANGE WITHOUT PRIOR NOTICE.
If at any time in the future you should need to dispose of
this product, please note that waste electrical products
should not be disposed of with household waste. Please
recycle where facilities exist. Check with your local
authority or retailer for recycling advice.

Page 12
Concept 101 LLC warrants to the original purchaser that the product will be free from
defects in material, parts and workmanship for the period designated for this product.
The warranty commences the day the product is purchased and covers up to a period of
one (1) year. Concept 101 LLC agrees that it will, at its option, replace the defective product
with either a new or remanufactured headset equivalent to your original purchase during
the warranty period. Should the Parts warranty period exceed the Labor warranty period,
Concept 101 LLC will supply at no charge for the remainder of the Parts warranty, any new
or remanufactured replacement parts as required by the product. During this period all
labor and service charges will becomethe responsibility of thecustomer.
Exclusions: This warranty does not apply to the appearance or exterior of the product
or construction. This warranty does not apply if the serial number is
altered or removed, or if there is any damage due to power line surge,
user damage to the AC power cord, connection to improper voltage
source, general misuse, accidents, or repair attempts by unauthorized
service agents. Other exclusions include ear pads, rechargeable and non-
rechargeable batteries.
REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS
THE EXCLUSIVE REMEDY OF THE CUSTOMER; Concept 101 LLC SHALL
NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES
FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS
PRODUCT, EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE
LAW. ANY IMPLIED WARRANTY OF MERCHANTABILITY OF FITNESS
FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED TO THE
DURATION OFTHE WARRANTY.
Warranty Information
The AT&T brands are used under license. Any repair, replacement, or
warranty service, and all questions about this product should be directed
to Concept 101 LLC at www.att.com/electronics or call 1 [phone]
from the USA or Canada.
Limited Warranty

Some states do not allow the exclusion or limitations of incidental or
consequential damages, or limitations on how long the warranty lasts.
In these cases the above exclusions or limitations may not apply to
other rights which vary from state to state.
Warranty Information
Obtaining Service: To obtain service, product literature, supplies or accessories please
call 1 888-920-8680, or visit our website, www.att.com/electronics,
to create a ticket for exchange/repair. Please make sure to provide
the date of purchase, model number and a brief description of the
problem. Our customer service representative will contact you or
send detailed return instructions.
Page 13
Concept 101 LLC does not warrant that the headset will work properly in all
environmental conditions, and makes no warranty and representation, either implied
and disclaims liability for any inaccuracies or omissions that may have occurred.
Information in this user’s manual is subject to change without notice and does not
represent a commitment on the part of Concept 101 LLC. Concept 101 LLC reserves the
right to make improvements to this user’s manual and/or to the products described
that is incorrect, misleading, or incomplete, please contact us through our website.

Page 14
- Wireless version - 5.0
- Charging time - approximately 4 hours
- Battery - 1000Mah
- Playback Time - up to 20 hours

Page 15
Memo
Purchase date:
Place of purchase:

www.att.com/electronics
© 2021 Concept 101 LLC. All Rights Reserved. AT&T and the AT&T logo are trademarks of AT&T
Intellectual Property licensed to Concept 101 LLC, New York, New York 10018. Printed in China.
Issue 1.1 AT&T 06/2021.
“The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc.