Atek Larco u-wav User manual

www.larco.com

U-WAV Touchless

Sensing Solution

Installation and Mounting Instructions

The U-WAV is a sensor switch designed for touchless activation of

automatic doors, lighting controls, or call points. Ideal for sterile

environments such as operating rooms or clean rooms, the U-WAV

provides a complete hygienic solution for various applications.

The Larco U-WAV touch free switch features always on, blue LED

backlighting uniquely designed to be aesthetically pleasing while

providing reliable operation. It is composed of very durable ABS

plastic. Installation is ﬂexible and easy.

u-wav technical Specifications

Technology K-Band Microwave Relay Output Ratings 125VAC, 60VDC @ 1A

Radiated Frequency 24.117GHz Current Consumption < 1.4W

Detection Range 0 - 15.0 in Temperature Range -4º - 140ºF

Detection Mode Motion (bi-directional) Relative Humidity up to 90%, Non-condensing

Operation

Mode

Toggle Activate On, Activate Oﬀ Weight < 3 oz

Pulse Activates for 1.2 Seconds LED Color Blue

Supply Voltage 12-24VAC, 12 - 30VDC Available Colors Grey, Black, White

Bevel Plate (Optional)

Microwave Sensor

Toggle (T) or Pulse (P)

Sensitivity

Normally Open

Normally Closed

Relay Common

Power12-24VAC

or 12-30VDC

Sensor Mounting Plate

Cover Plate

Description

ATEK Access Technologies

10025 Valley View Road, Ste. 190

Eden Prairie, MN 55344 U.S.A.

PH: 1.800.523.6996

FAX: 1.800.589.3705

+1.218.829.9797

www.atekaccess.com

223-0114-000 Rev. F 5/19

trademarks. ATEK assumes no responsibility for any errors which may appear in this document, reserves the right to change devices or speciﬁcations

detailed herein at any time without notice, and does not make any commitment to update the information contained herein. No licenses to patents or

other intellectual property of ATEK are granted by the Company in connection with the sale of Larco products, expressly or by implication.

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov

Snap sensor board assembly

onto mounting plate with

microwave sensor facing

mounting plate.

Choose desired mode

of operation, toggle (T)

or pulse (P) with selector

switch.

If using surface mount bevel,

run wiring through bevel

before making connections

to terminal block.

Adjust distance sensitivity

before attaching assembly

to mounting surface. Turn

clockwise for more sensitivity

and greater sensing distance.

Snap cover in position to

conceal mounting screws.

Aer initializing power to unit,

blue LED lights are ON when idle

and OFF during activation.

Installation and Mounting Instructions

FCC ID: USX-IPM165F

This devise complies with part 15 of the FCC rules. Operation is subject to the following two conditions. (1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B device, pursuant to part

15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment oﬀ and on, the user

is encouraged to correct the interference by one or more of the following measures. Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit diﬀerent from