Atel Electronics Unicorn 20 User manual
Unicorn 20
Console with Modular KVM Switch
Quick Installation Guide
Rev 1.0
Unicorn series QIG
1
Notes:
1. Please check all peripherals according the list before installation. To make sure
that the whole unit was not damaged and lost during shipping process. If you
encounter any problem, please contact your dealer.
2. Before installation, make sure all peripherals and computer have been turned
off.
3. Reliable earthing of rack-mounted equipment should be maintained. Particular
attention should be given to supply connections other than direct connections to
the branch circuit.
Hardware kits contents:
1. Rail with front and rear bracket x 2.
2. Bracket x 2
3. Screw (length = 6 mm) x 6
4. Screw x 8 (for combine bracket and rail)
5. Key x 2
Unicorn series QIG
2
Install console step:
1. Install four screws to combine bracket and rail.
2. Adjust rail with rear bracket to fit your cabinet
3. Install front and rear bracket on cabinet.
4. Repeat step 1~3 for the other side.
5. Push console into rails and push it to the end.
Unicorn series QIG
3
6. Install three screws (length = 6 mm) in rear of the console (Both sides) and finish
installation.
Unicorn 20
Console with Modular KVM Switch
Quick Installation Guide
