Atlas origin Series User manual

LED Flood Light
ORBSEL
SAVE THESE INSTRUCTIONS
BEFOREYOU BEGIN
Read and follow all safety instructions
WARNING
RISK OF FIRE, EXPLOSION ANDELECTRIC SHOCK
• This product should be installed, inspected, and maintained by a qualified electrician only,
in accordance with the NEC (National Electric Code) and all local codes.
• Turn offelectrical power before inspection, installation or removal.
• Use only UL (or other NTRL) approved wire for input/output connections.
Minimum size 18 AWG or 14 AWG for continuous runs.
• Make sure LEDs and drivers are cool to touch when performing maintenance.
Make sure the supply voltage is the same as the rated voltage of the luminaire.
• Do not install in a hazardous atmosphere, except where the ambient temperature does
not exceed the rated operating temperature of the fixture.
• Keep tightly closed when in operation.
PrepareElectricalWiring
ElectricalRequirements
Grounding Instructions
The grounding and bonding of the overall system shall be
done in accordance with NEC Article 600 and local codes.
The LED driver must be supplied with the voltage specified on the product label
and connected to an individual, properly grounded branch circuit protected by a 20
Ampere circuit breaker. Use min. 75°C supply.
Installation Instruction
06.23
Origin Series by Atlas Lighting | 1406 S. Mebane St. | Burlington, NC 27215 | 800-849-8485 | www.atlasled.com

Tools Required:
Before starting:
•Unpack the fixture and ensure that there are no
damaged ormissing parts.
•Ensure that the supply power is shut off.
Step 4: Restore power and check that the fixture
is working properly.
Step 2: Make the wiring connections according to
the diagram on Page 4. If dimming is not required,
make sure the dimming leads are capped.
Wire Strippers
Wire Cutters
Phillips screwdriver
Step 1: Feed the power cord into the junction box
or conduit. If j-box mounted, insert the threaded
portion of the knuckle into the threaded hole of
the cover. Secure the fixture with the Lock Nut.
Step 3: To aim the fixture, use a screwdriver to
loosen the Angle Adjustment Screw. Move the
fixture head to the appropriate position and
tighten the screw to lock it in position.
StandardInstallation
Installation Instruction
06.23
Origin Series by Atlas Lighting | 1406 S. Mebane St. | Burlington, NC 27215 | 800-849-8485 | www.atlasled.com
Page 2

Tunable Settings
Accessing the CCT/Wattage Selector
For CCT tuning, adjust the three (3) position slide switch for desired CCT:
Step1: Remove the conduit plug as shown and
set to the desired wattage/CCT.
NOTE: Replace the conduit plug securely to avoid water
entry into the fixture.
For Wattage tuning, adjust the three (3) position slide switch for desired wattage:
Accessing thePhotocontrol
NOTE: Replace the conduit plug securely to avoid water
entry into the fixture.
Step1: Unscrew the photocontrol and carefully adjust
the switch on the back side to enable or disable the
photocontrol. Take extreme care not to pull, pinch, or
disconnect the photocontrol wires
.
Installation Instruction
06.23
Origin Series by Atlas Lighting | 1406 S. Mebane St. | Burlington, NC 27215 | 800-849-8485 | www.atlasled.com
Page 3

Electrical Wiring Diagram
Installation Instruction
06.23
Origin Series by Atlas Lighting | 1406 S. Mebane St. | Burlington, NC 27215 | 800-849-8485 | www.atlasled.com
Page 4