ATOMI AT1393 User manual

。
 
 。

。
  
  
「 「 「
「 
「 「「 ’

「 

。 「 ’
 

 
：’
 
 h
ω
 －H
Ur w仰 ，、KH αAMhm
b对d
、．，xc
阳时丑 t队U
FE－
d川m
l：i 陋的M ’
－
LHH4·h
。


 



Model:AT1393

FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
· Reorient or relocate the receiving antenna.
· Increase the separation between the equipment and receiver.
· Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
· Consult the dealer or an experienced radio/TV technician for
help.
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.