ATTOWAVE NEW RL360 User manual

Manual
1. MUTE Button
Press and release MUTE button to turn off the audio for any alert. When an
audio alert is sounded, you can silence the alarm by pressing MUTE button.
Press MUTE button again to turn on the audio alert.
2. Mark Alert(MA)Button
Press and release MARK ALERT(MA) button to memory the location you have
selected. This location is stored in the memory and give an audio alert when
you pass the marked location.
3. Mark Mute(MM) Button
Press and release MARK MUTE(MM) button to mute the location you have
selected. This location is stored in the memory and mute an audio alert when
you pass the marked location
4. Volume Up(+) Button
Press Volume Up button to increase the audio volume.
5. Volume Down(-) Button
Press Volume down button to decrease the audio volume.
6. CITY/HIGHWAY Button
City mode reduces the annoyance of false alerts typically encountered in
urban driving areas.

Highway mode provides full audio warning any time radar(X, K, Ka) or
laser signals are detected, and is recommended for open road driving.
7. POWER Button
Press and release the POWER button to turn the unit on or off.
8. MENU Button
Pr ess the MENU button to enter menu mode.
9. DIM Button
Pr ess the DIM button to control LED brightness.
10. QUIET RIDE Button
Press this button to mute the audio under selected speed.
INSTALLATION
Mounting Guidelines
• Mount the RCU near the driver’s seat or host board.
• Do not mount your unit behind any objects. These obstructions have metal
surfaces which can affect communication with host board.
• To reduce the possibility of theft, conceal your unit when not in use.
• Make sure the mounting location you have chosen is relatively level and is clean
and dry. Clean with isopropyl alcohol if necessary to remove any waxes or
polishes.
• Separate the fastener strips. Peel the paper backing off each strip and adhere
one piece to the place and the other piece to the bottom of the unit.

Battery Replacement
The battery is equipped with the unit. To replace the battery, carefully open the
battery door.
LIMITED WARRANTY
The manufacturer warrant s this product ag ainst all d efects in materials a nd
workmanship for a period of one (1) year from the date of the original purchase, subject
to the following terms and conditions: The sole responsibility of the manufacturer under
this W arranty is limite d to either rep air or , at the o ption of the manufacturer ,
replacement of the unit. There are no expressed or implied warranties, including those
of fitness fo r a p articular purpose of merchant ability, which extend beyond the face
hereof.
SPECIFICATIONS
Carrier Frequencies: 433.92 MHz (Single Channel)
Frequency Stabilization Scheme : High-Q SAW Resonator Stabilization
Modulation Method : Amplitude Shift Keying (By Carrier ON/OFF)
Bit Duration : “1” – 2.25msec / “0” – 1.125msec
Operating Temperature Range: -10° C to +80° C
Storage Temperature Range: -20° C to +90° C
Power Requirements: 3V CR2032-type Li- Battery
FCC INFORMATION
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.