Audio enhancement XD MICROPHONE User manual

XD MICROPHONE
QUICK START GUIDE
Push to tlk
Bttery nd power
sttus indictor
Bttery chrging sttus
Tlk slide switch / Audio
mute control
SELECT—Adjust, chnge,
select which source (OWN,
OTHER or LINE)
Source Indictor
OWN, OTHER, LINE
Bttery nd power
sttus indictor
Up/Down—Remote
Volume controls
Bttery chrging sttus indictor
PWR/MUTE—Power On/O
nd mute control
REC—strts/stops recordings
Alert switchAlert switch

2
TEACHER MICROPHONE LINKING
1. With the microphone o, press the Link
button on the front of the amplifier or
side of the BEAM (Look for the blinking
yellow LED)
2. With the microphone o, press
and hold REC button. Then
promptly press and hold PWR
until microphone is linked.
3. Successful microphone linking will produce a beep through the system, and on the front
of the amplifier you will see an additional green LED

3
STUDENT MICROPHONE LINKING
LINKING THE MEDIA CHANNEL
1. Press and hold the PWR LINK
button on the back of the XD
Student Microphone
1. The microphone cannot be linked to the Media channel unless MIC 1 and MIC 2 channels
are on
2. Make sure the microphone needing to be linked, either the Teacher or Student, is turned o
3. Confirm that both Channel 1 and Channel 2 mics are on and connected to the amplifier
4. Follow XD Teacher or XD Student Microphone Linking section instructions
5. In around 10 seconds you should hear a beep and the amplifier LINK LED will be solid yellow
2. While holding use your thumb to
slide the TALK button up into to
the on position. Successful linking
will produce an audible beep as well
as an additional green LED.

4
AudioEnhancement.com · 800.383.9362
DC-40545.0923
CHARGING YOUR
XD MICROPHONE
1. Connect the Micro-USB plug of the charger to the DC input terminal of the microphone.
After connecting the microphone to the charger, the charge indicator (red) indicates the
charging status
2. When the charge indicator stops blinking, the microphone is fully charged. If the charge
indicator is blinking rapidly it means that the Micro-USB isn’t fully inserted
1. Press SELECT to choose the desired source to control. An LED will illuminate to indicate
the selected source. OWN will control the level of the microphone currently in use.
OTHER will control the other microphone if a second microphone has been linked. LINE
is not used with this system
2. Press the up arrow to increase the level of the selected source or the down arrow to
decrease the level
XD TEACHER MICROPHONE
VOLUME CONTROL
REMINDER
Charge the microphone at the end of each day to ensure its functionality and longevity.