Audio enhancement MIC360 User manual

MIC360®WITH
XD MICROPHONE
QUICK START GUIDE
XD Microphone
Insert Clip
Foam Ball
Foam Cap
SELECT—Change the
source (OWN, OTHER
or LINE) to be controlled
by the Up/Down remote
volume controls
Remote Volume Control
Source Indicator OWN,
OTHER, LINE.Indicates
which source will be
controlled by the Up/Down
remote volume controls
Battery and power
status indicator
Up/Down—Remote
volume controls
Charging status indicator
PWR—Power ON/O and
mute control
REC—starts/stops
recordings (additional
hardware required: camera)

2
XD MICROPHONE LINKING
1. With the microphone o, press the Link button on the front of the amplifier, side of the
BEAM, or rear of the XD Solo (Look for the blinking Yellow LED).
2. On XD Teacher Microphone
press and hold REC button. Then
promptly press and hold PWR until
microphone is linked.
3. Successful microphone linking will
produce a beep through the system,
and on the front of the amplifier and the
Teacher Microphone you will see an
additional Green LED.
4

3
INSTALLING THE
XD MICROPHONE
INTO THE MIC360®
1. Insert your fingers between the black
foam cap and the blue ball, and rotate
the black cap counter-clockwise.
(Figure 1)
3. Press and hold the PWR button on
the XD Microphone for 3 seconds.
The BATT LED will flash and then turn
solid green.
4. Use your thumb and index fingers to
pinch both sides of the internal XD
microphone clip, and pull outwards to
remove. (Figure 2)
5. Insert the XD microphone into the
XD microphone clip (Figure 3).
Once secure, connect the included
micro-USB and 3.5 mm audio
cables for charging and audio
passthrough. (Figure 4)
6. Re-insert the clip with the XD
Microphone until a click can
be heard. (Figure 5)
7. Replace the foam cap. Using your
fingers, grasp the cap, inserting it into
the hole at the top of the ball, and
twisting clockwise. (Figure 6)
2. Lift the black foam cap to reveal
the internal microphone holder.
Temporarily set the cap aside.
XD Microphone
Figure 1 Figure 2
Figure 3
Figure 4
Figure 5 Figure 6

CHARGING
YOUR MIC360®
The Mic360® features a charging passthrough cable, allowing you to charge the internal XD
Microphone without removing it from the Mic360.
1. Charge the microphone at the end of each day by removing the foam cap (see Figure 1
on Page 3), and connecting a micro-USB cable to the plug on the inside of the Mic360.
2. After connecting the microphone to the charger, the charge indicator (green) indicates
the charging status.
1. Press SELECT to choose the desired source to control. An LED will illuminate to indicate
the selected source. OWN will control the level of the microphone currently in use.
OTHER will control the other microphone if a second microphone has been linked. LINE
is not used with this system.
2. Press the up arrow to increase the level of the selected source or the down arrow to
decrease the level.
XD MICROPHONE
VOLUME CONTROL
DC-40688.0923 AudioEnhancement.com · 800.383.9362