Audiovox PRO9342FT3 User manual

Model PRO-9342FT
Owner's Manual
Page 1
FEATURES :
2 Two Button Programmable RF Transmitters
Two Channel Receiver ( capable of accepting 4 transmitters )
Anti-scan Technology
Remote Panic in all modes
Protected Valet
7 Function LED - Arm / Disarm / Zone1/Zone2/Zone3/Valet / Arming
Intrusion Alert with Memory
Audible Arm / Disarm / Defective Zone / Tamper Confirmation
Instant Siren Activation
Low Current Horn Output
True Last Door Arming ( hardwire only )
Defective Zone By - Pass
Hardwire or Voltage Sense Selectable
Active or Passive Arming Selectable
Programmable Auto Lock On / Off
Programmable Auto Unlock On / Off
Programmable Door Lock Pulse Duration 1 Second / 3.5 Seconds
Programmable Active or Passive Door Locks
User Programmable Permanent Chirp Delete
On Command RF Chirp Delete from Transmitter
6 Tone Multi - Tone Siren
RF Inhibit with ignition on
Parking Light Flasher
OPTIONS :
Single or Dual Stage Shock Sensor
Starter Disable
Remote Trunk Release
Remote Keyless Entry
Multiple Vehicle Capable
Remote Starter
Remote Power Window Roll Up
Remote Garage Door Interface
2 Button Remote Security System

ARMING THE SYSTEM - ACTIVE
1. Turn off the engine, exit the vehicle, and close all doors, hood lid, and trunk lid.
2. Press and release the Lock/"Arm" / Unlock/"Disarm" button on the keychain transmitter.
Red dash mounted L.E.D. begins to flash slowly.
Parking Lights flash one time.
Siren and or Horn sounds one chirp.
If the siren sounds 3 chirps, then you have left a door, trunk, or hood lid ajar.
Simply close the opened entry point to provide full protection. If the siren/horn
did not sound when arming, then the chirps have been turned off, and you
should refer to the section titled “ ELIMINATING THE ARM / DISARM CHIRPS “
in this manual.
Doors Lock - Optional
SILENT ARMING - ACTIVE
1. Turn off the engine, exit the vehicle, and close all doors, hood lid, and trunk lid.
2. Press and hold the Lock/"Arm" / Unlock/"Disarm" button on the keychain transmitter for
2 seconds.
Red dash mounted L.E.D. begins to flash slowly.
Parking Lights flash one time.
Siren/Horn will not sound.
If the siren/horn sounds 3 chirps, then you have left a door, trunk, or hood lid
ajar. Simply close the opened entry point to provide full protection.
Doors Lock - Optional
ARMING THE SYSTEM - PASSIVE ( AUTOMATIC )
1. Turn off the engine, exit the vehicle, and close and lock all doors, hood lid, and trunk lid.
Red dash mounted L.E.D. begins to flash rapidly, indicating 30 second passive
arming has begun.
2. Opening any protected entry point during the 30 second passive arming cycle will
immediately suspend automatic arming, and the 30 second passive arming cycle will re
start when all doors are closed. At the end of the passive arming cycle;
Red dash mounted L.E.D. begins to flash slowly.
Parking Lights flash one time.
Siren and or Horn sounds one chirp
If the siren/horn did not sound when arming, then the chirps have been turned
off, and you should refer to the section titled “ ELIMINATING THE ARM / DISARM
CHIRPS “ in this manual.
Doors Lock - Optional
Door locking during passive arming is a selectable feature. The alarm can be
programmed to allow the doors to lock only when arming using the keychain
transmitter, and they will not automatically lock during passive arming.
PROTECTION WHILE THE SYSTEM IS ARMED
Opening any protected door, hood, or trunk lid will cause the alarm to immediately
Page 2

Page 3
sound. The alarm will continue to sound for 30 seconds, then stop and continue
to monitor all protected entry points. If the thief left a door opened, the alarm will
sound for six 30 second cycles, remain armed and ignore that triggered zone.
Whenever the system is armed, the red dash mounted L.E.D. indicator will slowly
flash. This serves as a visual deterrent to the potential thief. The L.E.D. is a very
low current bulb, and will not cause the vehicle’s battery to drain, even when left
unattended for extended periods.
Whenever the system is triggered, the vehicle’s parking lights will flash for the
full 30 second alarm cycle, attracting visual attention to the vehicle.
Optional - Whenever the system is armed, the vehicle’s starting circuit will be
bypassed. If the thief should choose to ignore the siren/horn, the vehicle can not
be started.
Optional - Any strong impact to the vehicle will cause the alarm to trigger for the
full 30 second alarm cycle.
Optional - Any mild impact to the vehicle will cause the alarm to sound a short
series of warning tones.
DISARMING THE SYSTEM
1. As you approach the vehicle, press and release the Lock/"Arm" / Unlock/"Disarm"
button on the keychain transmitter.
Red dash mounted L.E.D. turns off.
If passive arming was selected during the installation, then the L.E.D. will start
flashing rapidly, indicating that the system is re arming automatically. Open any
door to suspend the automatic arming.
Parking Lights flash two times.
If the parking lights flashed three times, then the alarm was triggered in your
absence. Before turning the key on, examine the L.E.D. to identify which zone
was triggered.
Siren / Horn sounds two chirps.
If the siren/horn sounds 4 chirps, then the alarm was triggered in your absence.
Before turning the key on, examine the L.E.D. and refer to the INTRUSION
WARNING SIGNALS section of this manual to identify which zone was triggered.
If the siren/horn did not sound when disarming, then the chirps have been
turned off, and you should refer to the section titled “ ELIMINATING THE
Lock/"Arm" / Unlock/"Disarm" CHIRPS “ in this manual.
Doors Unlock - Optional
SILENT DISARMING
1. As you approach the vehicle, press and hold the Lock/"Arm" / Unlock/"Disarm" button on
the keychain transmitter for 2 seconds.
Red dash mounted L.E.D. turns off.
If passive arming was selected during the installation, then the L.E.D. will start
flashing rapidly, indicating that the system is re arming automatically. Open any
door to suspend the automatic arming.

Page 4
Parking Lights flash two times.
If the parking lights flashed three times, then the alarm was triggered in your
absence. Before turning the key on, examine the L.E.D. to identify which zone
was triggered.
Siren/Horn does not sound.
If the siren and or horn sounds 4 chirps, then the alarm was triggered in your
absence. Before turning the key on, examine the L.E.D. and refer to the INTRUSION
WARNING SIGNALS section of this manual to identify which zone was triggered.
Doors Unlock - Optional
INTRUSION WARNING SIGNALS
This system will inform you if an intrusion attempt has occurred while you were away from
the vehicle. If an intrusion attempt has occurred, the siren/horn will chirp 4 times and the
parking lights will flash 3 times when disarming the system. Enter the vehicle, and observe
the red dash mounted L.E.D. to identify which zone was triggered.
If the L.E.D. is flashing one time...pause...one time...pause...etc., then an intrusion
attempt was made to the optional shock sensor, or an accessory triggering device
that may have been added to the system.
If the L.E.D. is flashing two times...pause...two times...pause...etc., then an intrusion
attempt was made to a hood or trunk pin switch that was added to the system, or to
a light activated entry point if the alarm was installed using the voltage sensing
feature.
If the L.E.D. is flashing three times...pause...three times...pause...etc., then an
intrusion attempt was made through one of the vehicle’s doors.
These intrusion warning indicators are stored in the system’s memory, and will only be
erased when the ignition key is turned on.
VALET / SYSTEM OVERRIDE SWITCH
The valet switch allows you to temporarily bypass all alarm functions, eliminating the need
to hand your transmitter to parking attendants or garage mechanics. When the system is in
valet mode, all alarm functions are bypassed, however the remote panic feature and remote
door locks will remain operational. To use the valet mode;
1. Enter the vehicle, and turn the ignition key to the on position.
2. Move the valet toggle switch to the on position. The dash mounted L.E.D. will turn
on solid, and remain on as long as the system is in valet mode.
3. To return to normal operation, move the valet switch back to the off position any
time the ignition is on.
In the event that you lose your keychain transmitter, or if the transmitter fails to disarm the
system, the valet switch can be used to disarm the alarm. Open the vehicle’s door ( the
alarm will sound ). Turn the ignition key on, and move the valet switch to the on position. The
alarm will disarm, and the vehicle can now be started.
NOTE : Always remember to move the valet switch back to the off position. This will ensure
that the vehicle remains protected at all times.

Page 5
ELIMINATING THE NORMAL ARM / DISARM CHIRPS
As explained earlier in the manual, you can eliminate the chirps selectively any time you arm
or disarm the system simply by holding the Lock/"Arm" / Unlock/"Disarm" button for two
seconds. If you find the normal arming and disarming chirps annoying, they can be turned
off permanently, eliminating the need to hold the Lock/"Arm" / Unlock/"Disarm" button for
two seconds. To do this,
1. With the valet switch in the off position, turn the ignition key on then off.
2. Within 10 seconds, move the valet switch to on then off three times.
3. If the chirps were on before you started, then you will hear 2 chirps indicating
they have been turned off.
If the chirps were off before you started, then you will hear one chirp indicating
they have been turned on.
NOTE: If the siren/horn chirps two times, regardless of the valet switch operation as
described above, then the horn and siren chirps have been turned off via programming
features7&8. Contact your installation center or Audiovox technical department for
information on how to reinstate the chirp feature through programming.
NOTE: Whenever the chirps are by - passed, the 4 chirp intrusion indicator and 3 chirp
defective zone indicator will always operate. Since these are important warnings to you
that something has happened, they cannot be eliminated.
REMOTE PANIC OPERATION
The Lock/"Arm" / Unlock/"Disarm" button on your keychain transmitter also functions as a
panic switch for use in emergency situations. To use remote panic,
1. Press and hold the Lock/"Arm" / Unlock/"Disarm" button on the keychain
transmitter for 3 or more seconds. The alarm will immediately sound.
2. To stop the alarm, press and hold the Lock/"Arm" / Unlock/"Disarm" button on
the transmitter again for 3 seconds. If the button is not pressed, the alarm will
automatically stop after 30 seconds.
NOTE: All normal transmitter functions will operate in the panic mode.
ADDITIONAL REMOTE FUNCTION ( CHANNEL 2 )
This security system has an additional feature that can be connected to a number of
different optional accessories. Some of the more common uses for this channel are;
Remote Trunk Release
Remote Car Starter
Remote Window Closure
Remote Garage Door Interface
To activate the optional accessory, press and hold the option button 2 on the keychain
transmitter for 3 seconds.

Page 6
© 1999 Audiovox Corp., 150 Marcus Blvd., Hauppauge, N.Y. 11788 128 -5339A
PRO-9342FT
SYSTEM FUNCTIONS AT A GLANCE
DASH L.E.D. INDICATORS
RAPID FLASHING = PASSIVE ARMING
SLOW FLASHING = ARMED
OFF = DISARMED
ON SOLID = VALET MODE
3 FLASH...PAUSE = INTRUSION ZONE 3
2 FLASH...PAUSE = INTRUSION ZONE 2
1 FLASH...PAUSE = INTRUSION ZONE 1
SIREN CHIRP INDICATORS
1 CHIRP * = ARM
2 CHIRPS * = DISARM
3 CHIRPS = ARM / DOOR OPENED
4 CHIRPS = DISARM / INTRUSION
* These chirps are optional, and can be de - activated.
PARKING LAMPS
1 FLASH = ARM
2 FLASHES = DISARM
3 FLASHES = DISARM / INTRUSION
Your System Has These Features Activated
Single Stage Shock Sensor
Dual Stage Shock Sensor
Remote Keyless Entry
Starter Disable when armed
Auto Lock with ignition key
Auto Unlock with ignition key
Passive Arming
No Lock in passive mode
Hardwire doors, hood, and trunk
Siren Activation
Horn Activation