Audiovox IM-100 User manual

..
5. Pre-wire radio. Slide radio into din sleeve until it
locks into place. Note: Use either rear bushing
or perforated strap to secure rear of radio.
RADIO REMOVAL (IF NECESSARY)
1. Unsnap trimring on face of radio.
2. Insert removal tool in slotted holes on sides of
radio until bottomed. Spread tools outward slightly
and pull radio toward you. Remove tools and
slide radio fully out.
DIN MOUNTING (EXAMPLE:VOLKSWAGON)
SEE FIG. 1
1. Verify opening is within following dimensions:
A. Height 52mm- 53mm (23/64" -23/32")
B. Width 182mm -184mm (75/32" -71/4")
2. If opening is less, carefull file to exact size
required (DO NOT OVER FILE).
3. Remove din sleeve from radio and place into
opening.
4. Bend tabs outward to lock sleeve into dash.
rFjG:1l .~ ~ --USE EITHER BUSHING
I rlu. I I 11;r'.../ OR PERFORATED STRAP
@ TO SUPPORT REAR OF RADIO
.1 \LJ
\\
~
4
) ~
BEND TABS
~
~
~@~ I;/
~ ~' (J(~
~~ ~II ~lY A (;AO7
r
OUTWARD
..".J
",
~
~
0
DASH PANEL .;J-
DIN SLEEVE .~
-~~ l ~~
~~ ~
~
,
~ADIO REMOV~ """' ~
/ ~( ~
/I
,f '"""
:.,.( APPLY SLIGHT TRIMBEZEL (INSTALLED ON RADIO)
1...,j ~
REMOVAL TOOL TRIMRING
~
QUICKIE BOL T
/'

screws included with radio (see fig. 2)
CAUTION: Do not use longer screws or
damage to Internal parts of radio may occur
5. Re-Install radio / bracket assembly after wiring
radio.
6. Replace dash panel.
RADIO REMOVAL (IF NECESSARY)
1. Reverse installation procedure.
FACTORY STYLE INSTALLATION
(EXAMPLE:TOYOTA) SEE FIG.2:
1. Remove factory radio dash panel to expose
sub-dash.
2. Remove radio bracket assembly from sub-dash.
3. Remove and discard radio dummy panel attached
to factory radio bracket assembly.
4. Install radio Into bracket assembly using special
IM100/IM200/IM300RADIO
./'t.
"""' ~I;
~
...
r
~
..".,..
/
SHORT SCREWS
{INCL. w/RADIO)
~~ NOTE: IN SOME CASES IT WILL
BE NECESSARY TO BREAK OFF
"" " THE SMALL PLASTIC TABS ON MAP
~ POCKET IF THEY PREVENT FLUSH
FITTING OF RADIO
-- ,.
'#
~
:--
tJ/
FACTORYBRACKET/POCKETASSEMBLY
..-/ )1