Audiovox AS-9055 User manual

128-6831
1 of 2
3 Channel Remote
Car Starter
Model AS-9055
Owner’sManual
FEATURES :
w2 Programmable RF Transmitters
wThree Channel Receiver (capable of accepting 4 transmitters)
wOn-Board Start Relay
wOn-Board Accessory Relay
wOn-Board Ignition 1 Relay
wOn-Board Ignition 2 Relay
wIgnition 2 Relay Selectable On or Off During Cranking
wOn-Board Parking Light Relay
wIgnition 3 / Shock By-Pass / GM VAT Output (relay required)
wTach Signal Learning Circuit
wTwo ( + ) and Two ( - ) Safety Shutdown Circuits
wAlarm By-Pass Output
wAccessoryOutputs
(PulseBefore&AfterStart,DuringCrank&AfterShutDown)
wSelectable Steady or Flashing Parking Lights for Run Indication
wSelectable 5, 10, 15, 20 Minute Run Time

128-6831
2 of 2
© 2003 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788 128-6831
REMOTE STARTING THE VEHICLE
This will not start the vehicle if any one of the following situations exists;
The vehicle's hood lid is opened.
The gear shift selector is not in Park.
The brake pedal is depressed.
The safety control switch is in the Off position.
1. To start the vehicle, press and release the transmitter button two times
within 2 seconds. The vehicle will start and remain running for the pre-
programmed 5,10,15,20 minute run cycle. As a visual indication, the
parking lights will flash or remain on depending on the setting by your
installation center.
2. When you arrive at the vehicle, turn the ignition key to the ON position
(not the spring loaded start position), then step on the brake pedal to disen-
gage the remote starter. The vehicle will continue to run, but now on it's own
power.
NOTE: The engine will stop running before the pre-programmed run cycle
has expired if you perform any one of the following functions;
-Press and the button on the keychain transmitter two times within 2 seconds.
-Depress the brake pedal.
-Open the vehicle's hood
-Move the safety control switch to the Off position.
SAFETY CONTROL SWITCH
The red handle control switch allows you to temporarily disable the remote starting function
of the system and moving this switch to the Off position is recommended whenever the
vehicle is being serviced. When the system is disabled, the remote door locks and optional
accessories will remain operational.
FUNCTION SETTING CHART
To be completed by installer
Run Time 5 Min o10 Min o15 Min o20 Min o
Door Lock Timer 1 Sec/1 Sec o3.5 o1 Sec/Dbl 1 Sec o
Lights Pulse oSteady o