Audipack 390501 User manual
AUDIPACK
Industriestraat 2-4 Tel: +31-(0)79 931671
27 1 GT Moerkapelle Fax: +31-(0)79 93311
www.audipack.com
Plasma screen Stand (Presentation Display 390 01) Manual
The complete set consists of the following parts:
Note: the numbers also represent the order of assembly.
1. Foldable support
2. Feet, foldable in two
3. Bac -plate
4. Clamp (Other type than on the photo)
5. 4 star nobs (part of the clamp)
6. The specific Monitorbrac et (not on the photo)
for the relevante type of Plasma-screen
Position the support as indicated on photo 2. The 2 sides
must be placed in an angle of approx.
40°-45° of each other. This ma es mounting of the feet
much easier.
Hoo the front mounting nobs (see photo 7) of the
support through the front holes of the feet (no. 1 on photo
2). Pull the feet bac so that the front mounting nobs
slide in to the smaller part of the hole. Do not tight the
nobs yet!! First hoo the 2 bac mounting nobs
(no. 2 on photo 2) of the support through the holes in the
feet and pull them in the small part of the hole. Tighten
first the 2 bac mounting nobs (No. 2 on photo 2) firmly
(by hand) by turning them cloc -wise, then follow with
the front 2 mounting nobs (no. 1 on photo 2).
Ma e sure that the small part of the mounting nob
(the part the arrow points at on photo 7) goes through the
small part of the hole before tighten it. Do not use tools
for this. The placing of the actual Plasma screen in the
end will give extra strength.
Photo 1
Photo 2
Fold bac the parts laying on the ground and turn the Stand at his
feet
See photo 3:
By doing the above in this manner the hands are able to hold all 4
parts.
Fold the parts upright as indicated on photo 4.
Mount the bac -plate First hoo 1 side to the mounting nobs and
then the other side. Then tighten
the nobs by hand. Note: the small part of the nob (see arrow on
photo 7) must stic through the hole.
Photo 4 Photo 5
Mount the clamp (other type than on the photo), using the 4 star nobs. The tension which occurs on
the top part removes the last possible tolerance out of the Stand.
Tighten them firmly by hand (see photo 6)
Mounting nob, the arrow points to
the part which has to stic through
the holes. Not on to the side.
Mount the Monitorbrac et to the Plasma screen and hoo it onto
the clamp. See photo 8. Turn the hoo s on the clamp on to the
mounting nobs to secure the brac et.
Photo 3
Photo 6
Photo 8
Photo 7
Table of contents
