AUN W18 User manual

For Android phones
1.For Android System (wireless connection)
To activate this function, your android device must support
Multi-Screen/Wireless display. Names may differ from different
devices.
Turn on the projector, select Screen Mirroring as the Input Source,
then choose Android on the projector interface of Screen Mirroring
for Android System.
Turn on the Wi-Fi Switch in your Android device. Successfully
connected Wi-Fi on Android device is not a must unless the live
streaming content is needed.
Activate Multi-Screen function in your Android device and search
for the projector
Select RKcast-XXXXXX from the searching results to connect.
Your Android device display will be projected to the wall/screen
after a successful connection
The fluency of screen mirroring with wireless connection will be
affected by the network environment. A bandwidth of 100Mbit or
more is recommended when using screen mirroring.
Make sure your mobile device is closed to the projector when
using wireless connection. A distance within 1 meter is recommended.
Some mobile devices may not support screen mirroring due to the
compatibility.
Only for Mirror Screen function machine
Start Using

2.For Android System (wired connection)
Turn on the projector, select Screen Mirroring as the input source,
then choose iPhone on the projector interface of Screen Mirroring
for Android System.
Go to the settings of your mobile device, find Developer options
and turn on USB Debugging.
Connect your Android mobile device to the USB port of the
projector with the ORIGINAL USB cable.
Tap OK when your Android mobile device pops out. the windows
of Allow USB debugging, then your Android device will be projected
to the wall/screen.
The USB cable MUST be the ORIGINAL cable or the cable which
can transfer the data, otherwise screen mirroring may fail. You can
plug the cable into your laptop to check the availability of transferring
the data.
Some mobile devices may not support screen mirroring due to the
compatibility.
Some Android mobile devices may only transfer the display without
audio due to the protocol restrictions.
Only for Mirror Screen function machine
Start Using
The steps to turn on Developer options vary from different models
of Android device. You may check it from Internet or contact us for
the detailed steps. We take Samsung Galaxy S8+ as an example
Go to settings of your Android device, then tap About phone >
Software information> Build number. Continuously tap on Build
number for several times until it shows Developer mode had been
turned on. Get back to the settings of your mobile device, it will
show Developer options.

For iPhone phones
1.For iOS system
Turn on the projector, select Screen Mirroring as the input source
to enter the interface of Screen Mirroring for iOS system.
Go to the settings of your iOS mobile device and connect it to the
Wi-Fi of RKcast-XXXXXX (password: 12345678). Please ignore the
exclamation mark before it.
Swipe up the screen of your iOS mobile device, then tap Screen
Mirroring/AirPlay Mirroring and search for the projector.
Only for Mirror Screen function machine
Start Using
Setting with cellular data (wireless connection)