Aussie Traveller 380 mm User manual

1
Rangehoods Installaon Instrucons
Thank you for purchasing an Aussie Traveller Rangehood
The Aussie Traveller Rangehood has been specifically designed for use in
a full range of RV installaons including Caravans, Motorhomes, Cabins
and Boats where 12Volt power is used. Mounng and installaon of the
Rangehood should be performed as per the following instrucon and
installaon manual.
Maintenance is required for all Aussie Traveller Rangehoods. Ensure the
vents are cleaned regularly by unclipping the vent from the body, rinsing
under hot water or cleaning in a dishwasher. Ensure the rear/top vent is
clean and clear of any debris. Ensure there are no obstrucons in or
around the fan. Periodically check that the Rangehood remains secure
and has not moved or become loose during use or from travel.
Warranty. Your Aussie Traveller is covered by a 12 month product
warranty. Please read the warranty statement that is included with this
product.
Compliance. Installaon of this unit in a Recreaonal Vehicle requires a
minimum distance between the underside of the rangehood and
cooktop heang surfaces (ie gas flame aperture, electric element) of a
minimum 450mm. Ensure all relevant installaon regulaons are
adhered to. Changes may be applicable as compliance and regulaons
with various industries are amended.
Aussie Traveller Pack List – 530mm & 380mm
1. Rangehood 1pcs
2. Air outlet 1pcs
3. Wind deflector 1pcs
4. ST3.9×13 cross self-tapping nail with pan head 4pcs
5. ST2.9×13 countersunk head cross tapping nails 2pcs
6. ST4.2×13 cross self-tapping nail with pan head 4pcs

2
Note: The center of the cut hole is consistent with the center of the
installaon posion of the Rangehood.
Step 2: Install the Wind deflector (body) on the rangehood with ST2.9×
13 countersunk cross self-tapping nails, as shown in Diagram 2.
S
tep 1: The cut hole is shown in Diagram 1
Diagram 1
Diagram 2
OW (opening width) =72mm
OH (opening height) =55mm

3
Step 3: The rear Air Outlet is installed on the wall with ST3.9×13 cross
self-tapping nails with disk head, as shown in Diagram 3.
Diagram 4
Diagram 3
S
tep 4: Open the vent cover as shown in Diagram 4.

4
Step 5: Connect the wires to the 12Volt power source or wiring harness.
Ensure the wires are clear of the cavity and clear of any obstrucons.
The red power wire represents posive "+", and the black power wire
represents negave "-".
Note:Reverse connecon of the power cord will cause the rangehood
to malfuncon.
Install the rangehood into the cut out cavity or on the wall with ST4.2×
13 cross tapping nail with pan head, as shown in Diagram 5.
Diagram 5

5
Aussie Traveller recommends connecon to the 12Volt power source or
wiring harness is performed and completed by a qualified, competent
installer
Special Note:
1. The cut hole must be fixed according to the installaon posion
of the range hood, as shown in Diagram 1.
2. The power cord is placed in the air outlet when shipped, and can
be taken out when use.
3. No foreign maer is allowed to block the air outlet.
4. The fan needs to be protected during the installaon process,
and no foreign maer can enter and affect its normal operaon.
5. The wiring harness needs to be installed.
Diagram 6
S
tep 6: The installaon is completed, as shown in Diagram 6.

6
Special Note:
1. The cut hole must be fixed according to the installaon posion
of the range hood, as shown in Diagram 1.
2. The power cord is placed in the air outlet when shipped, and can
be taken out when use.
3. No foreign maer is allowed to block the air outlet.
4. The fan needs to be protected during the installaon process,
and no foreign maer can enter and affect its normal operaon.
5. The wiring harness needs to be installed.
AUSTRALIA
Poisons Hotline: 13 11 26
Emergency: 000
NEW ZEALAND
Poisons Hotline: 0800 POISON (0800 764 766)
Emergency: 111
CONTAINS BUTTON OR COIN CELL BATTERY—KEEP OUT OF REACH OF CHILDREN
Swallowing can lead to chemical burns, perforation of soft tissue, and death. In the case of Lithium batteries, fatal
injuries can occur in 2 hours or less if it is swallowed or placed inside any part of the body. Severe burns can occur
within 2 hours of ingestion. Seek medical attention immediately. No matter whether the battery is new or used.
If it is suspected your child or a person has swallowed or inserted a button/coin battery inside any part of the body,
contact the 24-hour Poisons Information Centre on 13 11 26 (Australia) or 0800 764 766 (New Zealand)
immediately for 24/7 fast, expert advice.
Always check your devices to ensure the battery compartment is correctly secured. Do not use if compartment is
not secure.
Dispose of used batteries correctly and out of reach of children—even when used they are still dangerous.

7
Rangehood Operaon Instrucons
Step 1:Connect to DC12v power supply.
The red power cord represents power "+", and the black
power cord represents "-".
Note:Reverse connecon of the power cord will cause
the rangehood to malfuncon.
Step 2: Turn on the power.
Note:This buon controls the operaon of the fan.

8
Note:Note:"+" and "-" control the air volume of the fan,
there are three levels.
Step 3: Turning on the LED light.
Note:This buon can turn on and off the light funcon.
Step 4: Setng the clock.
Note:Long press the power buon to enter the clock seng
mode.

9
Step 6: Set minute.
Note:Press the "+" "-" keys to increase or decrease minutes.
Step 7: Set hour.
Note:Press the power buon to switch to hour mode, press
the "+" and "-" keys to increase or decrease the hour.
This manual suits for next models
1
Popular Ventilation Hood manuals by other brands

Gorenje
Gorenje OK-004/II WHGS623E15X manual

KOBE
KOBE CH2730SQ3 Series Installation instructions and operation manual

Honeywell
Honeywell PRIMAIR PLUS Series instructions

Gorenje
Gorenje WHT631E2X / E100DI1S40BD2HTB manual

Kleenmaid
Kleenmaid Mini OM Instructions for use and warranty details

Gram
Gram EFV 3460-90 X instruction manual