AuthenTeak Kingsley-Bate St. George Bench SG40 User manual

Kingsley-Bate
SG40-50-60 St. George Bench
Assembly Instructions

KINGSLEY – BATE
Fine Garden Furniture
0ASSEMBLY INSTRUCTIONS FOR THE SG - 40/50/60
RIGHTEND FRAME LEFT END FRAME
SEAT BACK
1STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During asse mbly of furnit ure please match all joints with t he corresponding
letters or numbers stamped on the furniture.
2*NOTE
A TENON
B MORTISE HOLE
3STEP-II
Fit the B ACK tenons into t he RIGHT END FRAME
mortise holes. If necessary, gently rock the BACK
while pushing the t enons down into the m ortise holes
until the joints fit snugly together.
4STEP-III
Place the SEAT against the RIGHT END FRAM E as shown in the
assembly diagram and insert the tenon or tenons of the center seat brace
into the bottom rail mortise hole of the BACK.
NOTE: There is a front and back to the seat. Please make sure to match
the stamped letters or num bers that you will find on the seat braces
under the SEAT with those on th e END FRAMES, BACK or FRONT
SEAT RAIL.
5STEP-IV
Place the FRONT SEAT RAIL tenon into the RIGHT END FRAME
mortise hole. Make sure rounded edge of FRONT SEAT RAIL is
facing up. Place the SEAT tenon into FRONT SEAT RAIL mortise
hole.

STEP-V:
Fit the remaining LEFT END FRAM E mortise holes over and ont o the
BACK and the FRONT SEAT RAIL tenons. Using a rubber mallet or a
regular hammer with a wood block between the hammer and the wood,
drive the tenons and mortise holes until all the joints fit snugly together.
6STEP-VI
Hammer the dowels into their respectiv e joints. Make sure not to hit
other parts of the bench. To avoid dim pling the wood, we suggest that
you place a block of wood between the dowel head and the hammer
head for the last few blows. If the dowels are not completely flush, use
a saw to cut the ends and then sandpaper to smooth the tops.
**DO NOT FORCE DOWELS FURTHER THAN THEY CAN GO.**
8STEP-VII
Insert the brass screws into their respective pre-drilled SEAT holes (see
assembly diagram). Do not hammer in the screws, but drive them in
with a proper screw driver. Use of a power screwdriver or a drill with a
screwdriver bit could lead to damage of your furniture.
7STEP-VIII
Attach decorative brackets to their respective END FRAMES and to
the FRONT SEAT RAIL. Make sure longest end of bracket fits under
the FRONT SEAT RAIL. Brackets are for decorative use only.
IF YOU HAVE ANY QUES TIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE
DEALER NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU
FOR CHOOSING OUR FURNITURE.
*KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]