AuthenTeak Kingsley-Bate TR71 User manual

Kingsley-Bate
TR71 Essex 72" Oval Table
Assembly Instructions

KINGSLEY - BATE
Fine Garden Furniture
1ASSEMBLY INSTRUCTIONS FOR THE TR-71
TABLE TOP BASE TABLE LEGS
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furni ture please match the tenons and mortise holes with
the corresponding letters or numbers.
*NOTE
A TENON
B MORTISE HOLE
0STEP-II
Fit the TABLE LEG tenons into the TABLE TOP mortise holes. If necessary, gently rock
the TABLE LEGS while pushing tenons into mortise holes until joints fit snugly together.
STEP-III
Fit the BASE mortise holes over and ont o the exposed
TABLE LEG tenons and drive the joints together with
a rubber mallet. Drive BASE gently and evenly to
avoid damage to the BASE.

STEP-IV
Hammer dowels into respective joints. Make
sure not to hit other part s of the table. To avoid
dimpling the wood, we suggest you place a
block of wood between the dowel heads and the
hammer head on the last few blows. If dowels
are not com pletely flush, use a saw to cut the
ends and then sandpaper to smooth the tops.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE
DEALER NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU
FOR CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]