Avail GLANCE R03H30 User manual

[e-mail] 1300 945 720

32
Length + 85mm
Length = 300, 600, 900 or 1200mm
 76
85
148

Length = 300,

AVAIL QUALITY DESIGNS
}Australian Made & Owned!
}Toilet roll holder direction can be changed during installation
}Heritage/Provincial bathroom styling
}Scratch resistant high grade stainless steel
}Comfortable 30mm diameter rail
}Rail 150kg capacity and construction exceeds Australian Standard AS1428.1
and is fully approved and independently tested
32mm Diameter Grab Rail & Toilet Roll Holder - R03H30
GLANCE TOILET RAIL
FRONT
TOP
SIDE

[e-mail] 1300 945 720
GLANCE RAIL
INSTALLATION INSTRUCTIONS
1. Locate wall studs, install into at least one stud.
(minimum 2 screws per bracket).
2. Place rail on wall over centre of stud and mark hole positions
on wall through the holes of mounting bracket.
3. Drill pilot holes into wall stud t osuit mounting screws and
place silicon in holes to seal out moisture.
4. Install rail by screwing onto wall, minimum 2 screws in
each mount bracket (1 at top side, 1 at bottom side, use
appropriate mounting screws for the wall stud material,
supplied screws are for timber wall studs).
5. Push cover plates over mounting brackets until they cllip on.
CONTENTS:
2 x Wall Seal
6 x Stainless Screws
1 x Grab Rail
WARNING:
These rails are designed to be mounted onto wall studs or masonry walls. Installation is
recommended to be completed by qualified tradesperson who complies with the AS 1428.1-
2009 Design for Access and Mobility standard. It is recommended rail location is determined
by a qualified Occupational Therapist or trained professional to the AS 1428.1-2009 standard.
Correct installation is required to ensure safe, long term operation. Incorrect mounting can result
in reduced capacity of the rail which can result in injury to user and damage to the wall.
Wall Bracket
Wall Screw
Cover Plate
8
19
56
8
19
56
WALL BRACKET