manuals.online logo
Brands
  1. Home
  2. •
  3. Brands
  4. •
  5. Avocent
  6. •
  7. Antenna
  8. •
  9. Avocent Emerge HGA51G-DIR30 User manual

Avocent Emerge HGA51G-DIR30 User manual

Quick Installation Guide
Emerge™HGA51G-DIR30
High Gain 5.1 GHz Directional Antenna
To Contact Avocent Technical Support: CALL (888) 793-8763 USA or 353-61-715292 Shannon, IR VISIT www.avocent.com
Avocent, the Avocent logo, and Emerge are trademarks or registered trademarks of Avocent Corporation. All other marks are the property of their respective owners. ©2007 Avocent Corporation. All rights reserved. 590-626-501C
If the transmitter is to be wall-mounted,
allow sufficient clearance for the curved
antenna face to swivel freely in all directions.
Repeat steps 2 through 5 for the receiver.
For best results, position the wireless extenders
so they are on the same horizontal plane.
Using the signal strength LEDs for
guidance, swivel the curved face of transmitter
antenna head toward the directional antenna on
the receiver.
Using the signal strength LEDs for
guidance, swivel the curved face of receiver
antenna head toward the directional antenna on
the transmitter.
Extended Range Operation
The HGA51G-DIR30 directional antenna is
an accessory for Emerge wireless extenders,
which are factory-equipped with omni-
directional antennas. Directional antennas
provide extended range operation by focusing
the energy of radio waves into an intensified
directional beam. Extended distance operation
requires installation of at least one directional
antenna onto a transmitter and one onto a
receiver. Installation of two antennas per unit
will guard against signal blockage but will not
increase transmission distance.
If your wireless extenders are not already
properly placed and connected to audio, video,
power and control sources, then please refer
the appropriate product documentation before
proceeding with the instructions provided in
this document.
Facing the product, remove the omni-
directional antenna from the left-hand antenna
jack on both the transmitter and receiver.
The antennas loosen from the antenna jack
by turning the knurled fastener in a counter-
clockwise manner.
Select either directional antenna and
extend the assembly such that its connector
arm and antenna shaft are parallel with each other at
the knuckle joint.
Engage the center socket of the antenna
connector arm onto the center pin of the transmitter
antenna jack. Turn the knurled fastener clockwise
until finger tight to secure the antenna.
If the transmitter is to be shelf or rack mounted,
raise the antenna head such that the antenna
shaft is pointed upward and perpendicular to the
connector arm at the knuckle joint. This motion
requires proper alignment of the knuckle joint,
which can be accomplished by rotating the antenna
shaft. Once vertical, swivel the curved antenna face
toward the intended receiver.
Emerge HGA51G-DIR30 Antenna
2
The following will help you install your directional
antenna easily. Should you require further assistance,
please contact Avocent Technical Support.
1
3
Antenna Head
(curved face shown)
4
5
6
7
8
Knuckle Joint
Antenna Shaft
Connector Arm
Knurled Fastener
Directional
Antenna
Omni-
directional
Antenna
Shown with EWMS1000 Extender
Quick Installation Guide
Emerge™HGA51G-DIR30
High Gain 5.1 GHz Directional Antenna
To Contact Avocent Technical Support: CALL (888) 793-8763 USA or 353-61-715292 Shannon, IR VISIT www.avocent.com
Avocent, the Avocent logo, and Emerge are trademarks or registered trademarks of Avocent Corporation. All other marks are the property of their respective owners. ©2007 Avocent Corporation. All rights reserved. 590-626-501C
Transmitter and receiver pair with properly aligned antennas
Additional Information
Emerge extenders feature an intelligent dual
antenna system, in which the antenna with
the strongest receive signal becomes the
active antenna for transmission while the
other becomes passive. For this reason the
directional antenna, due to its increased
sensitivity, will become the active transmission
antenna when environmental conditions are
static. Under such conditions there is no
reason to install multiple directional antennas
on a single device. Transient environmental
conditions, however, as might occur in a
warehouse in which boxes are routinely
stacked and moved, can impair the signal of
the active antenna, resulting in activation of
the passive antenna. Under these shifting
conditions, it might be advantageous to install
two directional antennas on a single Emerge
wireless extender.
Emerge HGA51G-DIR30 directional antennas
are compatible with each other as well as with
omni-directional antennas. It is recommended
to install at least one directional antenna on
both the transmitter and receiver because
the receiver’s acknowledgements must be
properly received by the transmitter.
The directional antenna achieves extended range
by concentrating its radiated power in a narrow
(approximately 30 degree) arc. Therefore, care
must be taken to ensure that all receivers paired
with a transmitter are located within the 30
degree arc of its directional antenna.
Because a directional signal is focused into
a relatively narrow arc, it is easily blocked by
objects such as steel beams, HVAC ducts and
re-bar. For this reason, care must be taken to
avoid obstructions in the signal path. Moving
the transmitter or receiver a few feet may
improve performance significantly.
The HGA51G-DIR30 antenna is designed to
provide 8 dB of gain within the 5.150 – 5.825
GHz UNII bands.
The following will help you install your directional
antenna easily. Should you require further assistance,
please contact Avocent Technical Support.
Emerge HGA51G-DIR30 Directional Antenna
Shown with EWMS1000 Extender

Popular Antenna manuals by other brands

DAPAudio EDGE EUA-1 user manual

DAPAudio

DAPAudio EDGE EUA-1 user manual

Aaronia MagnoTRACKER Series manual

Aaronia

Aaronia MagnoTRACKER Series manual

BrasilSat SCB37-120 manual

BrasilSat

BrasilSat SCB37-120 manual

EchoStar HUGHES JUPITER AN9-098-G installation guide

EchoStar

EchoStar HUGHES JUPITER AN9-098-G installation guide

Sirio Antenne SO-918-2 installation manual

Sirio Antenne

Sirio Antenne SO-918-2 installation manual

Teleco Motostat digimatic 65 Installation guide and user's manual

Teleco

Teleco Motostat digimatic 65 Installation guide and user's manual

H3C ANT-2506V-M6-E installation guide

H3C

H3C ANT-2506V-M6-E installation guide

M2 Antenna Systems 902-5 YAGI manual

M2 Antenna Systems

M2 Antenna Systems 902-5 YAGI manual

Caratec CASAT4065 user manual

Caratec

Caratec CASAT4065 user manual

Camos CSA-600 Multi instruction manual

Camos

Camos CSA-600 Multi instruction manual

Mobile Mark TMA-24A-302CT Quick install guide

Mobile Mark

Mobile Mark TMA-24A-302CT Quick install guide

MFJ 1798 manual

MFJ

MFJ 1798 manual

Sirio Antenne GPA 27-45M installation manual

Sirio Antenne

Sirio Antenne GPA 27-45M installation manual

Hama 179823 operating instructions

Hama

Hama 179823 operating instructions

EARDATEK KINGSAT KM-V3 manual

EARDATEK

EARDATEK KINGSAT KM-V3 manual

Cisco Aironet AIR-ANT2568VG-N quick start guide

Cisco

Cisco Aironet AIR-ANT2568VG-N quick start guide

Tet-Emtron TE-AEA quick guide

Tet-Emtron

Tet-Emtron TE-AEA quick guide

Shively Labs 6812DIN Instruction Manual Installation, Operation, & Maintenance

Shively Labs

Shively Labs 6812DIN Instruction Manual Installation, Operation, & Maintenance

manuals.online logo
manuals.online logoBrands
  • About & Mission
  • Contact us
  • Privacy Policy
  • Terms and Conditions

Copyright 2025 Manuals.Online. All Rights Reserved.