3
PRIMUS
Avoid malfunctions and damage to the product as a result of im-
proper use
If toilet is moved from a cold location to a warm location, condensation
may form. Leave the unit switched o for a few hours.
Do not install the toilet in rooms where the temperature will be less than 4
°C ( 39 °F ).
Do not place open flames, candles, cigarettes, or similar objects on or by
the toilet.
Do not reuse old hoses or water lines. Please use new water lines when
installing.
Do not install the toilet next to items that would potentially expose the toilet
to a large amount of water.
Do not climb on or stand on the product.
Do not place any heavy objects on the lid.
Do not open or close the lid or seat with force.
Do not expose the batteries to hot surfaces or direct sunlight to reduce the
risk of battery leakage.
If battery acid has leaked, avoid contact with skin, eyes and mucous mem-
branes. In case of contact with the acid, flush the aected areas with large
amounts of clean water and seek medical assistance immediately.
FCC INSTRUCTIONS
Please note that changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These lim-
its are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communi-
cations. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television re-
ception, which can be determined by turning the equipment o and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
