Aztech DSL700P User manual

ADSL MODEM CARD
Users Manual
(Configured for SingTel Magix Service)
DSL700P
Version 1.1

Contents
○○○○○○○○○○○○○○○○○○○○
5
6
7
8
8
9
9
12
23
25
19
25
26
29
Introduction .....................................................................
Before You Begin ..............................................................
2.1 Minimum System Requirements ......................................................
2.2 Safety Precaution ............................................................................
2.3 Installation Notes............................................................................
Setting Up the Modem Card ............................................
3.1 Installing the Modem Card ..............................................................
3.2 Connecting the Modem Card ..........................................................
Installing the Modem Driver .............................................
Using the Internet ............................................................
Uninstalling the Modem Driver .........................................
ADSL MAPI Icon .............................................................
A-1 MAPI LEDs .....................................................................................
A-2 MAPI Menu ....................................................................................
Technical Specifications....................................................
Frequently Asked Questions .............................................
Troubleshooting Guide .....................................................
Technical Support ............................................................
13
33
37
41

ADSL Modem User’s Manual
4
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
This page is intentionally left blank.

5
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
1.Introduction
Introduction
Congratulations on your purchase of DSL700P ADSL Modem card!
ADSL, which stands for Asymmetric Digital Subscriber Line, is the latest
communication technology that offers faster and uninterrupted Internet access.
The DSL700P is a PCI based Controller-less ADSL modem. It is capable of
data rate in both Full-Rate and G.Lite, with Full Rate transmission up to 8
Mbps downstream, 640 Kbps upstream and G.Lite transmission up to
1.5 Mbps downstream, 512 Kbps upstream.
With ADSL modem, you do not require a new phone line. Neither do you
need to switch your existing phone line between phone communication and
Internet surfing. The ADSL modem makes use of your existing phone line for
Internet surfing and at the same time, allows you to talk on the phone! As your
phone line is dedicated to your home, your connection to the Internet will also
be highly secured and reliable!
DSL700P definitely meets more than comfortably, the demands of todays
bandwidth intensive applications!
○○○○○○○○○○○○○○○○○○○○

ADSL Modem User’s Manual
6
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
This page is intentionally left blank.

7
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
2. Before You Begin
2.1 Minimum System Requirements
2.1.1 Hardware
•IBM PC-based computer with Pentium®166 processor
•A CD-ROM drive
•A free PCI Bus slot
•32MB RAM
•30MB free hard disk space (system files and modem drivers only)
2.1.2 Software - Operating System
Windows®98 Second Edition
Before You Begin
This chapter contains information that you need to know before
installing your modem card. Please go through them before
proceeding with the installation.
○○○○○○○○○○○○○○○○○○○○

8
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
2. Before You Begin
2.2 Safety Precaution
•Do not remove your card from its protective bag until you are ready to
install it.
•Always try to hold your card by its edges. Avoid touching any electronic
components on your card.
•Static electricity can cause permanent damage to your card. To prevent
such a damage, you must ground yourself during the installation:
»Use a grounding strap - a coiled wire with a clip at one end and an
elastic strap at the other. Wear the strap around your wrist and
attach the clip to any non-painted metal surface of your computer
chassis.
»If you do not have a grounding strap, touch any non-painted surface
of your computer chassis before you begin installation, and again
every minute or so until the installation is completed.
2.3 Installation Notes
•The graphics and screen illustrations shown in this manual may differ from
what you see in your system, but the steps still apply.
•A Philips screwdriver is required.
•The documentation for your computer should come in handy during the
installation. Have it ready by your side.
•If you have an existing non Plug-and-Play modem installed in your computer,
you must first uninstall its modem driver before you remove the card. Refer
to the documentation of your existing modem for details.
If your existing modem is Plug-and-Play, you may proceed to install your
new modem.

9
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
3. Setting Up the Modem Card
3.1 Installing the Modem Card
Youneed to removeanyexisting modeminstalled inyour computer.If your
modemisnonPlug-and-Play, youneed touninstallitsmodemdriver before
you remove it. Check your existing modem documentation for details on
this.
Power off your computer and any connected devices before installing
your modem!
¶Remove the cover
of your computer.
Setting Up the
Modem Card
This chapter contains information on how to install and connect the
modem card.
○○○○○○○○○○○○○○○○○○○

10
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
3. Setting Up the Modem Card
PCI Bus Slot
Cover Plate
Mounting Screw
ÌAlign your card with the
selected PCI Bus slot and
firmly push it into the slot.
If the card does not slide
in, do not force it. Make
sure that the card is
aligned properly and try
again.
ËLocate any
available PCI Bus
Slot and remove
its cover plate.
Keep the mounting
screw to secure
your card later.

11
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
3. Setting Up the Modem Card
ÍSecure your card to the
computer chassis with
the mounting screw.
ÎReplace the cover of
your computer.
This completes the ADSL modem card installation. Please proceed to the
following section on the card connection for ADSL line.

12
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
3. Setting Up the Modem Card
3.2 Connecting the Modem Card
This completes the ADSL modem card connection. Please proceed to the next
chapter to install the driver for your modem.
Ë
Telephone set
Telephone
Wall Socket
Telephone
extension cord
from Telephone set
to Telephone Wall Socket
Ê
Ì
†Micro-Filter
DSL700P
The use of micro-filter
optimizes the G.Lite operation.
Theconnection totheTelephone setisoptional. ThePhonejackprovides
convenience to users who need to use the phone when accessing the
computer.
The Micro-Filteris not required if you are not connecting to aTelephone
set.

13
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
4. Installing the Modem Driver
Installing the
Modem Driver
This chapter contains information on how to install the driver for
ADSL modem card in Windows®98 Second Edition.
○○○○○○○○○○○○○○○○○○○
1. The screens illustrations in this chapter assume that yourCD-ROM
Drive is ‘D’. Please change the letter according to your own CD-
ROM drive.
2. System may prompt for your Windows 98 Second Edition
Installation CDduring the driver installation. Have it ready by your
side.

14
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
4. Installing the Modem Driver
2
Click the option "Search for the
best driver for your device.
(Recommended)." and click Next.
1
Power on your computer to start Windows. It will detect the newly-installed
ADSL modem card and prompt for its driver.
Place the DSL700P Installation
CD into your CD-ROM Drive and
click Next.

15
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
4. Installing the Modem Driver
3
Select Specify a location and
click Browse... .
Navigate to the directory
\Win98SE on your CD-ROM and
click OK.
Click Next.
4
Click Next again to proceed
installation with the specified driver.
Allow some time for your system to
install the driver.

16
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
4. Installing the Modem Driver
Click Yes to restart
your system.
7
Upon copying files
complete, click Finish.
6
This completes the driver installation for your ADSL modem card in Windows®
98 Second Edition.
5
System may prompt for your Windows 98 Second Edition Installation
CD.
Replace the DSL700P
Installation CD in your CD-
ROM drive with your Windows
Installation CD and click OK.

17
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
4. Installing the Modem Driver
8
i) From your Windows taskbar, click
Start > Settings > Control Panel.
ii) Double-click System icon.
iii) From the Device Manager tab,
double-click Network adapters.
You should see DSL700P ADSL
Network Modem listed.
(If the component is not listed, reinstall your driver.)
Allow some time for your system to restart. Upon system rebooted, please
proceed with the following step to verify if your card has been installed properly.

18
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
4. Installing the Modem Driver
This page is intentionally left blank.

19
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
5. Using the Internet
○○○○○○○○○○○○○○○○○○○
Using the Internet
This chapter contains information on creating a dial-up icon for the
Magix Internet Connection.
2
Click Next.
1
For connection to Magix Internet, you need to create a dial-up icon.
From your Windows taskbar, click Start > Programs > Accessories
> Communications > Dial-Up Networking.

20
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
5. Using the Internet
Enter Magix for the
computer name and select
DSL700P device. Click Next.
3
4
Enter Magix as the Host
name / IP address and
click Next.
5
Click Finish to complete
the dial-up icon settings.