B-Tech BT882 Instruction Manual

BT882
PROJECTOR CEILING MOUNT
WITH ADJUSTABLE DROP
INSTALLATION GUIDE & PARTS LIST
This Pack Contains 1 Mount
Installation Safety Notes.....................................................................................................................2
Parts List.............................................................................................................................................4
Installation Instructions.......................................................................................................................6
Product Dimensions..........................................................................................................................15
B-Tech Contact Details.....................................................................................................................16
CONTENTS
INSTALLATION TOOLS REQUIRED
FEATURES
12mm (1/2") masonry bit
or 8mm (11/32") wood bit
Level
(optional)
PLEASE KEEP THIS FOR FUTURE REFERENCE
●Suitable for projectors up to 10kg (22lbs)
●Hand lever for easy adjustment of ceiling drop:
Min 500mm (19.7”) – Max 750mm (29.5”)
●+/-90° tilt adjustment, +/-90° roll adjustment & 360° swivel
●Unique ‘carousel’ mounting plate for universal compatibility
●Suitable for angled / cathedral ceilings
●Integrated cable management
●Maximum distance between any two fixing points on
projector: 340mm (13.5”)
●Suitable for projectors with M2.5, M3, M4, M5 and M6 fixings
●Simple installation with all mounting hardware and fixings included
Crosshead
screwdriver
Drill Pencil
13mm (1/2") spanner
or socket
REG. DESIGN NO: 3016251

2
INSTALLATION SAFETY INSTRUCTIONS
CAUTION: This ceiling mount is intended for use only with the maximum
weights indicated. Use with projectors heavier than the maximum indicated
may result in instability causing possible injury.
Do not attempt to install this product until all instructions and warnings have been read and
properly understood. Please keep these instructions for future reference.
B-Tech International Limited, its distributors and dealers are not liable or responsible for
damage or injury caused by improper installation, improper use or failure to observe these
safety instructions. In such cases, all guarantees will expire.
General
B-Tech International Ltd recommends that a professional AV installer or other suitably qualified
person install this product. Great care must always be taken during installation as most AV
equipment is of a fragile nature, possibly heavy and easily damaged if dropped.
If you do not fully understand the instructions or are not sure how to install this product safely,
then please consult a professional for advice and/or to install this product for you. Failure to
mount this product correctly may cause serious injury or death both during installation and at
any time thereafter.
Do not mount any AV equipment that exceeds the specific weight limit of the product you are
installing. This weight limit will be clearly stated on each product and its packaging and will
vary from product to product.
Product location
Please pay careful attention to where this product is located. Some ceilings are not suitable for
installation.
If located in a public or frequently populated area ensure that the product is out of the
immediate reach of people. If any AV equipment is to be suspended over the likely path or
location of people then great care should be taken to secure all parts of the installation from
falling.
When drilling holes in ceilings it is essential to avoid contact with electrical cables and water or
gas pipes contained within. Use of a good quality live wire detector and hidden object locator is
therefore recommended. Only drill into structures when you are sure it is safe to do so.
Fixing hardware
It is highly recommended that all wall fixing screws be used where supplied and that the
purpose of all other fixing hardware is fully understood. In some cases more AV equipment
fixing hardware will be supplied to accommodate different models of equipment and set up
configurations.
The installer must be satisfied that any supplied fixing hardware is suitable for each specific
installation. If any fixing screws or included hardware are deemed not sufficient for a safe
installation then please consult a professional or your local hardware store.
Hazard limitation
When routing cables take advantage of any built in cable management features that the
product might provide and ensure that all cables are tidy and secure. Check to see that any
moving aspect of the product can do so unhindered by any cabling.
Some products have moving parts and the potential to cause injury through the crushing or
trapping of fingers or other body parts.
Particular attention to the nature of moving parts is required especially when assembling
installing and adjusting during set up.
Immediately after installations double-check that the work done is safe and secure. Double-
check all necessary fixings are present and are of ample tightness.
It is recommended that periodic inspections of the product and its fixing points are made as
frequently as possible to ensure that safety is maintained. If in doubt consult a professional AV
installer or other suitably qualified person.

3
CS
Společnost B-Tech International Ltd. doporučuje provést instalaci tohoto produktu prostřednictvím odborného
instalátora AV či jinak způsobilé osoby. Společnost B-Tech International Ltd, její distributoři a prodejci nenesou
odpovědnost za škody nebo zranění způsobená nevhodnou instalací. Tento výrobek je nutno umístit do vhodné
konstrukce a používat jen po uvedenou maximální výšku.
DE
B-Tech International Ltd. empfiehlt, dass dieses Produkt durch einen qualifizierten AV-Techniker oder eine
andere Person mit geeigneter Qualifikation installiert wird. B-Tech International Ltd, ihre Distributoren und
Händler können nicht für durch fehlerhafte Montage verursachte Beschädigung oder Verletzung haftbar bzw.
verantwortlich gemacht werden. Dieses Produkt muss auf eine geeignetem Untergrund montiert werden und darf
nur bis zum angegebenen Höchstgewicht verwendet werden.
ES
B-Tech International Ltd. recomienda que un instalador de audio y video profesional u otra persona debidamente
cualificada instalen este producto. B-Tech International Ltd, sus distribuidores y concesionarios no se hacen
cargo ni se responsabilizan de ningún daño o lesión provocados por una instalación inapropiada. Este producto
se debe montar en una estructura adecuada y se debe utilizar soportando solamente hasta el peso máximo
indicado.
FR
B-Tech International Ltd. recommande de confier l’installation de ce produit à un installateur AV professionnel ou
à une autre personne dûment qualifiée. B-Tech International Ltd, ses distributeurs et ses revendeurs ne
sauraient être tenus responsables de tout dégât ou de toute blessure résultant d’une installation incorrecte. Ce
produit doit être monté sur un support approprié et utilisé dans la limite du poids maximum indiqué.
IT
B-Tech International Ltd. consiglia di affidare l’installazione di questo prodotto a un installatore specializzato o ad
altra persona adeguatamente qualificata. B-Tech International Ltd, i suoi distributori e rivenditori non accettano
alcuna responsabilità nei riguardi di eventuali danni o infortuni causati da un’errata installazione. Questo prodotto
deve essere fissato a una struttura idonea e utilizzato unicamente sino al peso massimo indicato.
NL
B-Tech International Ltd. adviseert om dit product te laten installeren door een professionele AV-installateur of
andere hiervoor gekwalificeerde persoon. B-Tech International Ltd, haar distributeurs en dealers zijn niet
aansprakelijk of verantwoordelijk voor schade of letsel die is veroorzaakt door onoordeelkundige installatie. Dit
product moet worden gemonteerd aan een geschikte constructie, waarbij het aangegeven maximum gewicht niet
mag worden overschreden.
PL
Firma B-Tech International Ltd. zaleca, aby ten produkt byłinstalowany przez profesjonalnych instalatorów AV
lub inny odpowiednio przeszkolony personel. Firma B-Tech International Ltd, jej dystrybutorzy i dealerzy nie
ponosząodpowiedzialności za uszkodzenia lub obrażenia ciała powstałe w wyniku nieprawidłowej instalacji.
Niniejszy produkt musi byćzamontowany na odpowiedniej powierzchni, a podczas użytkowania nie wolno
przekraczaćpodanego maksymalnego obciążenia.
PT
A
B-Tech International Ltd. recomenda que a instalação deste produto seja efectuada por um instalador de AV
profissional ou outra pessoa devidamente habilitada. A B-Tech International Ltd. e os seus distribuidores e
concessionários não são responsáveis por danos ou lesões causados por uma instalação incorrecta. Este
produto tem de ser montado numa estrutura adequada e utilizado somente até ao peso máximo indicado.
RU
Компания B-Tech International Ltd. рекомендует, чтобы установка данного изделия производилась
инженером по установке аудио-видеотехники или другим специалистом ссоответствующей
квалификацией. Компания B-Tech International Ltd., ее дистрибьюторы идилеры не несут ответственности
за повреждения или травмы, полученные врезультате неправильной установки. Данное изделие должно

4
BT882
PARTS LIST
Suitable for loads
up to 10kg (22lbs)
5
2
4
1
6
7
8
9
10
11
13
14
16
17
10
9
15
12
Tube and Ceiling Plate
Assembly
Interface Assembly
20 21
3

5
PLEASE KEEP THIS FOR FUTURE REFERENCE
REF PART NAME QTY
1 CEILING BRACKET 1
2 UPPER EXTENSION POLE 1
3 LOWER EXTENSION POLE 1
4 ADAPTOR 1
5 CEILING BRACKET COVER PLATE 2
6 M8 METAL WASHER 4
7 M6 X 6mm GRUB SCREW 2
8 M6 X 10mm GRUB SCREW 2
9 M8 SPRING WASHER 5
10 M8 X 20mm HEX SCREW 5
11 ADJUSTMENT LEVER 1
12 SECURITY CABLE 1
13 CAROUSEL 1
14 THUMBWHEEL 4
15 LONG LEG 4
16 SHORT LEG 4
17 CAROUSEL COVER PLATE 2
18 M6 DOME NUT 4
19 M6 X 11mm SPACER (FOR PART K) 4
20 3mm HEX KEY (FOR PARTS 7 & 8) 1
21 5mm HEX KEY (FOR PART 10) 1
REF INTERFACE KIT QTY
A M2.5 X 12mm SCREW 4
B M3 X 12mm SCREW 4
C M4 X 12mm SCREW 4
D M5 X 12mm SCREW 4
E M6 X 12mm SCREW 4
F M3 METAL WASHER (FOR PARTS A & B) 4
G M5 METAL WASHER (FOR PARTS C & D) 4
H M6 METAL WASHER (FOR PART E) 4
I M6 X 3mm METAL WASHER (USE AS SPACERS IF
INTERFACE SCREWS ARE TOO LONG) 4
J M6 X 6mm METAL SPACER (USE AS SPACERS IF
INTERFACE SCREWS ARE TOO LONG) 4
REF FIXING KIT QTY
A1 M10 X 60mm COACH BOLT 4
A2 M10 METAL WASHER 4
A3 No. 12 WALL PLUG (FOR PART A1) 4
A
F
B
G
CD
H
E
J
I
18
19 A3
A2
A1

6
INSTALLATION INSTRUCTIONS
1Attach upper extension pole to ceiling plate.
2
21
1
6
9
10

7
2
1
5
i.
ii.
ONLY USE PART A3 WHEN FIXING
TO CONCRETE CEILINGS
A3
1
A2
A1
Fix ceiling plate to the ceiling.

8
3Attach interface assembly to projector.
i. Attach legs to projector.
H
GF
E
D
C
B
A
15
16
IJ

9
ii. Attach part 4 to carousel and place on legs.
iii. Attach the carousel to the legs.
21
10
9
13
4
14
13
Using quick release hand wheels or using secure dome nuts and spacers.
13
18
19

10
4Attach projector to lower extension pole.
20
4
3
8
8