BAC 400SX User manual

WELDING INVERTER FOR PIN BRAZING
USING INVERTEC 400SX with the BAC Easybond Generator Gun.
1./ Switch power on at the rear of the unit
A. Power Switch: Turns input power On/Off to the machine
B. Input Cable: Connect it to the mains.
2./ Set the welding mode to stick user defined parameters
3./ Set Current to 240 Ampere (245 max) using the output current control knob
Ensure that you read the Operator’s Manual and fully
familiarize yourself with all the safety and operational
requirements prior to using this equipment

3./ Voltage will auto set to 45V max, this can be checked by switching the display from
Amperes to Volts.
4./ Set by rotating “Hot Start” knob between 30%-50% of the full scale.
5./ Set Arc Force knob to maximum.
6./ Ensure that the Brazing Gun is plugged into the positive terminal and the Earth is plugged
into the negative Terminal.
7./ Fire off several test Brazing Pins in accordance with the Pin Brazing Gun Operation
manual. If required make necessary adjustments using the Output Current and/or the Hot
Start knob. Do not set output Current higher than 245 amperes.
8./ Once the Brazing Pins are firing to the required standard make a note of the settings for
future reference.
BAC Corrosion Control Ltd
Stafford Park 11, Telford, Shropshire, TF3 3AY
Tel: [phone]
Fax: [phone]
Email: [e-mail]