BAGNODESIGN BDB-MAL-53175-A-WH User manual

Freestanding Bath Tub Installation Guide
BDB-MAL-53175-A-WH

2
Important Please Read
Remove all packaging and check the product for missing parts or damage before starting installation.
Any alterations made to this product and ttings may infringe water regulations and invalidate the guarantee.
The Installation must comply with all Local/National Water Supply Authority Regulations/Byelaws and Building and
Plumbing Regulations.
We strongly recommend that you use a qualied and registered plumber.
Please note this product requires 2 persons or more to lift and maneuver this product into
position.
General Installation
The installation of any of Freestanding Bath requires the concealing of pipework into the oor. This must be planned
prior to installation of the product.
To the installer: Please read and follow this instruction carefully, as the guarantee is only valid if the bath is installed as
directed.
Please leave this installation manual with the end user once the bath has been installed.
Parts Supplied:
Acrylic freestanding bath x 1
Overow waste set x 1
Fixing Screws x 1pack
Parts Needed:
Suitable waste pipe and connector
Suitable bath trap

3
BDB-MAL-53175-A-WH

4
Step 1
Remove the bath from the box and carefully unwrap the protective packaging.
Step 2
Ensuring that the area the bath will be located is level, lift the bath into its nal position.
Check that the bath is sitting level to the nished oor and not rocking.
The bath is supplied with adjustable legs, if required these can be adjusted with a spanner.
Step 3
This bath is a two piece bath, at this stage the inner bath tub should be lifted from the outer panel. Using the
protective plastic, to protect the bath, turn the bath upside down to make any adjustment to the legs. The height of
the legs should not be increased too much as this will result in a gap between the bath and outer panel.
Step 4
Connect the supplied overow and waste ttings to the bath.

5
Step 5
Locate the outer panel in its nal position. Mark out the oor and drill the nished oor and secure the outer panel
into position using the provided screws.
Pre drilled holes can be found in the base of the panel
Note: Prior to drilling please consider any pre-installed water proong.
Step 6
Lift the inner bath into position and using a suitable bath trap and connection pipe connect the bath waste to the
preinstalled waste pipe. Once connected lower the bath into the outer panel.
Once satised the connection is complete we recommend testing the bath to ensure there are no leaks.
Now the bath is in place, position and plumb in the brassware.