Bambu Lab Kit-002 User manual

Wireless Mouse Components Kit-002
Assembly Guide

1
2
4
5
6
7
8
3
① Scroll Wheel ② Power wires ③ Mouse Foot Pads (x4) ④ PCB Board ⑤ 2.4G Module ⑥ Lens
⑦ Toggle Switch ⑧ BT2x8 Screws(x6)
List

Installation Steps
① Remove 3D print suppo structures.

① Remove the protective lm from the sensor suace.
② Place the PCB board and toggle switch in their respective positions.

1
2
2
2
2
① Install the scroll wheel onto the PCB.
② Install the PCB onto the base plate, taking care to align with the toggle switch and the positioning holes.

① Inse the positive and negative terminals, as well as the socket, into their respective slots.
② Gently tuck the positive (red) wire into the wire groove.

② Secure the PCB cover plate to the base plate using 3 screws.
① Be careful to avoid pressure on the wires from the PCB cover plate.

① Inse the front of the mouse into the front end of the upper shell.
② press down gently to secure the rear of the mouse.
③ Secure the base plate with two screws.
④ Attach the mouse foot pads.
1 2
3
4

① Inse the batte.
② Inse the 2.4G module. ③ Press down and snap on the batte cover.
3
2

Note 2: If the mouse disconnects during initial staup, you can peorm a pairing operation as described below:
1. Keep the mouse powered o.
2. Inse the receiver into the computer.
3. Place the mouse as close as possible to the receiver.
4. While holding down the left button, right button, and scroll wheel button, power on the mouse.
5. Continue to hold down the 3 buttons for 4-5 seconds.
6. When the arrow on screen changes, power o the mouse.
7. Power the mouse on again to resume normal use.
Note1:Push in the area of the batte cover depicted above to open it.