Bartuf Flexi-News Series User manual

Assembly Instructions
Flexi-News™ cross category
1. 2. 3.
4.
First, take base (A) and ensure brakes are
applied to the two castors that have them.
Braked castors are at opposite corners of
base.
With the base locked in place, drop the RH
panel (C) into the base (A) as shown above.
Next secure the RH panel (C) in place with
x4 thumb screws (J). Repeat steps 2 and
3 for the LH panel (B). Both LH and RH
panels should now be in place as in Fig. i
5. 6.
Guide the slots on the sides of the shelf
onto the metal studs and push down until
the shelf ‘snaps’ into place.
Next place the insert panel (D) onto the
base as shown.
Take the first confectionery shelf (E) and locate
the slots on the sides onto the lowest set of metal
studs on the right hand panel of the existing display
and the insert panel (D).
Tel: [phone] Fax: [phone] email: [email protected] web: www.bartuf.com
All dimensions are approximate and may be subject to change.
All drawings and designs are protected by design right and copyright©
Patents GB 2293538B.GB 2317328 US 6,112,912
D
E
Flexi News™
cross cat.
tall twin
B001733
Flexi News™
cross cat.
quad
B001728
Flexi News™
cross cat.
twin
B001731
E
E
PUSH
DOWN
A
C
Fig. i
J
x1
x1
x1/2
x1/2
x8
x1
x1/2
x4/8
x1/2
x1/2

Finally place the divider (I) in the 140mm deep
top shelf (H). The display is now complete and
ready to be merchandised.
Tel: [phone] Fax: [phone] email: [email protected] web: www.bartuf.com
All dimensions are approximate and may be subject to change.
All drawings and designs are protected by design right and copyright©
Patents GB 2293538B.GB 2317328 US 6,112,912
7. 8. 9. 10.
11.
Take the pre-assembled 3 tier shelf (F) and
locate it between the 4 tier module on the right
and the body panel on the left. Snap the shelf (F)
into place with the slots on the shelf locating with
the metal studs on the body panels.
Take the small news shelf (G) and position over the
metal studs on the left hand panel of the existing
display (B) and the insert panel (D).
Guide the slots onto the metal studs. Push down
and pull towards the front until the shelf ‘snaps’
into place.
Install the 140mm shelf (H) on the top set of
metal studs and snap in place as shown in
step 9.
B
G
H
I
G
G
i.PUSH
DOWN
ii.PULL
DOWN