BASEPUMP RB750-EZ User manual

Tools Required: Hand saw, screw driver, PVC cement, hole saw, tube cutter, and tape measure
Mount the Basepump Ejector on to the floor joist.
Mount the Basepump against the face of the joist,
underneath the floor joist, or on a wall.
All mounting brackets and hardware included.
Tools: Screw driver
Materials Required: none
Estimated install time: 20 Minutes
M
Mount Basepump Ejector
Install the Suction Pipe by using PVC pipe.
The Basepump location does not need to be directly over
the sump pit. It may be piped straight into the pit or with
45 or 90 degree elbows if necessary.
Tools: Saw, tape measure, and PVC cement
Materials Required: EZ: 1” PVC White Pipe x 10 ft.
: 45 deg. elbows PVC, if needed
PRO: 1-1/4” PVC White Pipe x 10 ft.
: 45 deg. elbows PVC, if needed
Estimated install time: 20 Minutes
I
I
Install Suction Pipe
Install the Discharge Pipe using either rigid PVC pipe or the supplied hose or both.
Outdoor discharge: (shown)
A separate discharge is recommended which will require
drilling a hole through the fascia board to the outdoors.
Tools: Saw, Hole Saw Size: EZ= 1-1/2”; PRO = 2”
Materials Required: EZ: 1” PCV 90 deg. elbow,
PRO: 1-1/4” PVC 90 deg. elbow
Estimated install time: 60 Minutes
Indoor discharge: Piped into the discharge line of the primary
sump pump. Refer to instructions for this type of installation.
Tools: Saw, tape measure
Materials Required: 1-1/2” PVC Tee
EZ: 1-1/2” x 1” PVC reducer fittings
PRO: 1-1/2” x 1-1/4” PVC reducer fitting Install Discharge Pipe

Mount the Float Valve to the suction pipe and connect the transfer tube.
Simple mounting, no special tools required.
Tools: Screw driver
Materials Required: none
10 Minutes
Mount the Float Valve
Connect Water Line by inserting the tee into a cold
water line and pipe to the Basepump.
The water line can be piped with copper, PEX, or CPVC
tubing. Basepump EZ & PRO models include ¾” push
connection solder-free fittings.
Tools: Tube cutter, tape measure
Materials Required: ¾” Copper, PEX, or CPVC tubing.
60 Minutes
C
o
n
n
Connect Water Line
Install the high Water Alarm.
Alarm & float switch easily mounts to the suction pipe, all hardware included.
Tools: Screw driver
Materials Required: none
10 minutes
A) Cost of the Basepump: $____________________
B) Cost of the additional materials: $______________
C) Estimated installation time: ________Hours x $_________ per hour = $_______________
Total estimated project cost: $___________________________
Note: The above installation times are based on actual estimates from professional plumbers using a typical
installation. These are only estimates. Long runs of water piping, sump pit configuration, small enclosed areas, etc. will
affect the installation time.