
• Remove rechargeable batteries from the toy before recharging
them.
• Rechargeable batteries are only to be charged under
adult supervision.
• Please follow the correct polarity, [+] and[ - ].
LOW BATTERY INDICATORS:
CAUTION
• Replace all batteries of the same type/brand at the same time.
• The supply terminals are not to be short-circuited.
• Remove exhausted batteries from the toy.
• Batteries should be replaced by adults.
• Batteries should be recycled or disposed of as per state and local
guidelines.
Battery Installation
1. Lay theInteractive Care Bear down so that the battery compart-
ment faces upwards. Interactive Care Bearrequires 2 x 1.5V“AAA”
or LR03 size batteries (included).
2. Using aPhilips screwdriver (not included)remove the screw on the
battery compartment cover.
3. Remove any existing batteries and insert new batteries according
to the diagram. Ensure that the positive and negative polarities
match the illustrations inside the battery compartment.
4. Replace the battery compartment cover and tighten screw using
the screwdriver. Do notover-tighten.
Item#
22050
basicfun.com ©2020 Basic Fun!, Inc. , Boca Raton, Florida 33431, USA.
Care Bears™ and related trademarks:TM & © 2020Those Characters From Cleveland,LLC.
Used under license by Basic Fun! Cloudco Entertainment with logo:TM & © 2020 Cloudco,LLC. All Rights Reserved.
Manufactured under license. Basic Fun! products are safety tested and comply with ASTM F963.
Made in China. Each sold separately, subject to availability.
Colors and styles may vary from photos as we continue to modify and improve our products.
ADULTS NOTE: Remove all tags and plastic fasteners before giving toy to child.
Please keep this package and instruction sheet for future reference.
WARNING! Not suitable for children under 36 months. Small Parts. Choking hazard.
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) the device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy, and if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communication. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
When the batteries become weak, the Interactive Care Bears
will become slow and unresponsive or fail to connect with
each other in Bear to Bear Mode. When this happens, slide
loss when subjected to any electrostatic discharge, radio
frequency interference, or sudden power surge/interruption.
The user is encouraged to reset the equipment should any of
these occur.
•
[standard (Carbon-Zinc), Alkaline or rechargeable] or rechargeable
• Use only fresh batteries of the required size and recommended
type.
IMPORTANT BATTERY INFORMATION
CAN ICES-3(B)/NMB-3(B)
-
+
-
+