NOIR
Wall 3 hole mounted basin mixer matt black
20004010435
CARE AND MAINTENANCE:
To maintain the appearance of this product, ensure that it isregularly
cleaned only using a clean, soft damp cloth. A solution of warm
water and a mild detergent may be used where necessary, and then
the fitting rinsed thoroughly and wiped dry. Any other cleaning action
will invalidate your warranty.
The diffuser should be unscrewed and cleaned periodically in warm
water. Abrasive cleaners, scouring cleaners and acidic cleaners
must not be used under any circumstances. Avoid contact with all
solvents (including chlorinated solvents, ketones or acetones as
these may result in surface deterioration or etching).
Isolate the water to the tap before performing any form of internal
maintenance.
CLEANING THE CARTRIDGE
The concealed cartridge should give trouble free service, but in the
event of any problems, servicing is straight forward.
With an Allen key loosen the screw on the handle. Pull off the
handle and unscrew the cover. Using the correct size spanner
unscrew and remove the retaining nut. Pull out the cartridge taking
note of it’s orientation. Washthecartridgewith clean running water
and make sure that any trapped debris has been removed. Dry and
lightly grease the seal (only use silicone grease) and replace the
cartridge followed by the nut, cover and handle.
INSTALLATION GUIDELINES
1.
Installation should be carried out by a competent engineer, in
accordance with water regulations.
2.
If isolating valves aren’t already fitted, fit them to the inlet feeds.
3.
Before installation, ensure supply pipes are flushed clean.
Debris or loose particles will affect the efficiency of the ceramic
disc cartridge. Failure to flush through pipe work before
installation of taps may cause serious damage to the ceramic
disc cartridge, for which bathstore will not be liable.
4.
Hot & cold pressures should be equally balanced.
5.
To prolong the life of the cartridges in hard water areas and
reduceservicingperiods we recommend that a suitablewater
softener be fitted.
6.
The cavity in the wall needs to be 45mm-65mm depth, 270mm
wide and 50mm High.
7.
Remove the handles spout and covers.
8.
Install thebody in thecavity and connect tothe hotand cold
feeds, ensure that it is secure.
9.
Fit handles andspout,turn onwatersupply,flushthroughand
check for leaks. Then turn off water supply and remove the
handles and spout.
10.
Measureout and cut holes in the tiles/wall panels for controls
and spouts to connect through.
11.
Fit the tiles/wall panels
12.
Refit covers handles and spout
13.
Turn on the water supply and check again forleaks.
1
Date last modified:30/01/2018
