BAYSWATER BAYW001 User manual

Product Material Product Diameter
Connection SizeHeating Element Wattage
Colour/FinishFitting Instruction
CE Certification
PRODUCT DETAILS
Country of Origin
Label Colour
Label Size Label Qty
PACKAGING DATA OUTER BOX DIMENSIONS (If Applicable)
Box Colour
Box Qty
Height (mm) Width (mm) Depth (mm) Gross Wgt Kg
Nett Wgt Kg Height (mm)
PRODUCT DIMENSIONS PACKAGING DIMENSIONS
Height (mm) Width (mm) Length (mm) Depth (mm) Width (mm) Depth (mm) Gross Wgt Kg
Length (mm)
XBarcode
CODE: DESCRIPTION: CATEGORY: Wastes & Extras
263
77
77
0.67
85
110
200
0.67
United Kingdom
N/A
Yes
Brass
77mm
Not Applicable
11/4"
White Cardboard Box
1
White Label
2
5055275890387
Basin Bottle Trap W/ 190mm Ext Tube
BAYW001
Chrome
100
50

GENERAL FITTING GUIDE
for BOTTLE TRAPS
GUARANTEE & AFTERCARE
When installing or using tools, extra care must be taken to avoid damaging the finish or fitting.
To maintain the appearance, please ensure it is cleaned regularly using a clean soft damp cloth
only. Abrasive cleaners or detergents must not be used as they may cause surface deterioration.
The company provides a guarantee against faulty material or manufacture excluding serviceable
parts, providing they have been installed, cared for and used in accordance with our instructions.
The company reserves the right to continually evolve its product lines without notification.
The company will not accept any liability regarding specification changes and their consequences
unless previously quoted by the company in writing.
1. Assemble knurled nut (B) onto the plated metal tube (C) under the top flange with the wide
end facing upwards to receive the waste assembly. Slide the second knurled nut (D) onto the
plated metal tube (C) ensuring the wide end is facing down.
2. Push the plastic sleeve (E) into the top of the bottle trap main body (F) ensuring the lip seats on
the neck of the trap. Insert the metal tube (C) into the centre of the plastic sleeve and lock the
knurled nut (D) firmly into position.
3. This trap is designed to connect to a standard 1.1/4" metal waste outlet pipe (I).
Slide the knurled nut (H) and tapered washer (G) over the waste pipe and tighten the nut.
4. When fitted onto the basin waste outlet the washer (A) must be placed inside the knurled nut
to form a seal between the trap and waste.
INSTALLATION PROCEDURE
FLAT WASHER (A)
KNURLED NUT (B)
PLATED METAL TUBE (C)
KNURLED NUT (D)
BOTTLE TRAP BODY (F)
TAPERED WASHER (G)
WALL FLANGE (J)
WASTE OUTLET PIPE (I)
PLASTIC SLEEVE (E)
KNURLED NUT (H)
PRODUCT SHOWN WILL VARY
DEPENDING ON MODEL