Beech ovens TBR0500 User manual

Page 1 of 2 2009-11-13 (C)
Changing the TBR0500 from Charcoal to Gas
Removing the Charcoal plug
1. Open the Control Cabinet door
2. Remove the 2 screws that hold the plug in place
3. Slide the plug out
Remove the 2 screws holding the
plug in place and slide plug out
Control Cabinet Door

TBR0500 - Changing from Charcoal to Gas Instruction.doc Page 2 of 2
2
Removing the Gas system
1. Turn off and disconnect the gas line from the inlet to the cabinet
2. Open the Control Cabinet door
3. Remove the 2 nuts holding the valve bracket in place
4. Slide the entire Gas Assembly slightly to the left and then slide the system out
Install in reverse order.
NOTE: If changing from Gas to Charcoal, use only very short screws to mount the
plug as there will be refractory material directly behind the stainless steel. Be careful
not to crack the refractory when inserting screws.
Remove the 2 nuts
holding the valve bracket
in place. Slide to left and
drag Gas system out.
Gas Inlet to cabinet (Valve)