Behringer Ultra Octaver UO300 User manual

ULTRA OCTAVER UO300
3-Mode Octaver Eects Pedal
Thank you for showing your condence in us by purchasing the Behringer ULTRA OCTAVER UO300.
This high-quality eects pedal creates a monster sound by adding two additional tones using your
guitar—one and two octaves below the original tone. Thanks to its high-performance features you’ll
get natural, clear octave sounds with constant pitch, even for staccato playing.
Octave eect is possible due to a circuitry that generates signals one or more octaves below the input signal.
1. Controls
(1) The RANGE selector allows you to optimize the eects pedal for HIGH, MID and LOW frequencies
and use instruments with dierent frequency ranges (guitar, bass guitar, keyboard, etc.)
(2) The DIRECT control adjusts the level of the original input signal.
(3) The OCT 1 control adjusts the level of the generated signal one octave below the original signal.
(4) The OCT 2 control adjusts the level of the generated signal two octaves below the original signal.
(5) The blue ON/BATT LED illuminates when the eect is activated. It also serves as a battery level indicator.
(6) Use the footswitch to activate/deactivate the eect.
(7) Use this ¼" TS IN connector to plug in the instrument cable.
(8) The ¼" TS OUT connector sends the signal to your amp.
Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V battery,
press the hinges with a ballpen and remove the pedal cover. Be careful not to scratch the unit.
◊◊ The UO300 has no on/o switch. As soon as you insert the jack into the in connector,
the UO300 begins running. When not using the UO300, remove the jack from the
in connector. This extends the life of the battery.
The SERIAL NUMBER is located at the bottom.
(5)
(1)
(7)
(4)
(6)
(3)(2)
(8)
V6.0

ULTRA OCTAVER UO300
2. Safety Instructions
Do not use near water, or install near heat sources. Use only authorized attachments/accessories.
Do not service product yourself. Contact our qualied servicing personnel for servicing or repairs,
especially when power supply cord or plug is damaged.
3. Warranty
For the applicable warranty terms and conditions and additional information regarding Music Tribe’s
Limited Warranty, please see complete details online at musictribe.com/warranty.
4. Specications
In
Connector ¼" TS
Impedance 500 kΩ
Out
Connector ¼" TS
Impedance 1 kΩ
Power Supply
9 V , 100 mA regulated
Behringer PSU-SB
USA/Canada 120 V~, 60 Hz
China/Korea 220 V~, 50 Hz
U.K./Australia 240 V~, 50 Hz
Europe 230 V~, 50 Hz
Japan 100 V~, 50 - 60 Hz
Power connector 2 mm DC jack,
negative center
Battery 9 V type 6LR61
Power consumption 30 mA
Physical/Weight
Dimensions approx. 54 x 70 x 123 mm
(H x W x D) (2.1 x 2.8 x 4.8")
Weight approx. 0.33 kg (0.7 lbs)
Behringer is constantly striving to maintain the
highest professional standards. As a result of these efforts,
modifications may be made from time to time to existing
products without prior notice. Specifications and appearance
may therefore differ from those listed or shown.

ULTRA OCTAVER UO300
FEDERAL COMMUNICATIONS COMMISSION
COMPLIANCE INFORMATION
Responsible Party Name: Music Tribe Commercial NV Inc.
Address: 5270 Procyon Street,
Las Vegas NV 89118,
United States
Phone Number: [phone]
ULTRA OCTAVER UO300
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
•• Reorient or relocate the receiving antenna.
•• Increase the separation between the equipment and receiver.
•• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is
connected.
•• Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesiredoperation.
Important information:
Changes or modications to the equipment not expressly approved by MUSIC Tribe can void the user's
authority to use the equipment.
Hereby, Music Tribe declares that this product is in compliance with Directive 2014/30/EU,
Directive2011/65/EU and Amendment 2015/863/EU, Directive 2012/19/EU, Regulation 519/2012 REACH
SVHC and Directive 1907/2006/EC.
Full text of EU DoC is available at https://community.musictribe.com/
EU Representative: Music Tribe Brands DK A/S
Address: Ib Spang Olsens Gade 17, DK - 8200 Aarhus N, Denmark
ULTRA OCTAVER UO300

ULTRA OCTAVER UO300
Music Tribe accepts no liability for any loss which may be suered by any person who relies either wholly or in part upon any description, photograph, or
statement contained herein. Technical specications, appearances and other information are subject to change without notice. All trademarks are the property
of their respective owners. Midas, Klark Teknik, Lab Gruppen, Lake, Tannoy,Turbosound,TC Electronic, TC Helicon, Behringer, Bugera, Oberheim, Auratone and
Coolaudio are trademarks or registered trademarks of MusicTribe Global Brands Ltd. © Music Tribe Global Brands Ltd. 2021 All rights reserved.