BEKA Picture Frame Easel User manual

Manufactured by:
Beka, Inc. • 542 Selby Avenue • St. Paul, Minnesota 55102 • USA
1-888-999-BEKA(2352) • www.Bekainc.com
PICTURE FRAME EASEL
Your Picture Frame Easel is ready
for use. Place it on a table, hang it on a
Wall with the cord, or use the 2 wall screws to screw
to a wall. Add paper as desired.
Contents:
- Framed Art Surface
- Stand-O Blocks & Paper Holder Rod
- Paper Roll
- Hardware & Cord
Mounng a Paper Roll:
• Remove wing nuts and washers from above the stand-o blocks.
• Remove Paper Holder Rod; slide the rod through the Paper Roll.
• Re-posion the Paper Holder Rod over the bolts going through the Stand-O Blocks; secure with
washers & wing nuts.
• To use paper, slide it under the top paper cuer strip, across the art surface and under the cuer
strip at the boom of your easel.
• To tear o used paper: Holding the Picture Frame Easel in place, pull paper down to desired point.
Place your hand on the paper sll over the art board to hold it in place and tear paper by liing it
up against the cuer strip. If you prefer, you can place the enre easel on a table for stability; un-
roll paper and tear it o as usual.
Warning – Adult Assembly Required!
Enclosed hardware includes small pieces,
so may present a choking hazard to children under 3.
Once assembled, an adult should
check hardware periodically for ghtness.
Always dispose of unused hardware & plasc bags
appropriately, as it may pose choking hazards .

Art Surface: Your Picture Frame Easel features a dry-erase marker board surface. For best
results, use high quality dry-erase markers. Always test markers on a corner of the board to
insure easy erasure before allowing general use, as the performance of individual markers
may vary. Clean the enre surface regularly. Even the best markers can leave stains if le on
the art surface for extended periods of me. If stains do occur, many may be removed with
special whiteboard cleaners (“cleaners” should only be used by adults). Do not use abrasive
household cleaners on the marker board surface. They can damage the clear surface coang
that allows dry-erase markers to be used. Pro p: If a wipe o marker has dried and is hard to
erase, use the same marker to color over the old drawing to help make it easier to erase.
Have Fun!!!
Thank you for choosing Beka!
Your new Beka product is
designed for fun and function,
and made by Minnesota craftsmen
in our St. Paul shop, where
we’ve produced specialty
products since 1973.
We’re always adding new items for you
to enjoy, so please ask your favorite
specialty retailer about other
Beka products.
To learn more about Beka,
visit our web site
www.Bekainc.com
Thank you,
The Beka Folks