Beko DWD5414 User manual

DWD5414 Programme Chart and Quick Reference Guide
Before starting, it is essential that ou carefull read right through the Installation
& Operation Instruction booklet before plugging in to the mains socket.
Detergent
compartment
A=25 cm³ /
15 cm³
B=5 cm³
Programme
sequence
Consumption
figures
Water (Litres)
Energ (kWh)
Duration (min)
Programme
s mbols and
temperatures
Programme
selection
17,5
1,67
115
Wash
Cold rinse
Hot Rinse
Hot rinse
Prewash
A+B
Drying
Heavily soiled
dishes
re uiring Hot
pre-wash
A+B
14
1,02
165
Wash
Cold rinse
Hot rinse
Drying
Prewash
Most
economic
programme
for normally
soiled dishes
A
Wash
Cold rinse
Hot rinse
Drying
11,8
0,79
30
Lightly soiled
dishes
30 minute
programme
-
4,2
-
14
Pre-wash to
rinse and
loosen residue
- awaiting full
load - then
select a
Programme
Stop
Prewash
* Values declared on the product or in the operating instruction booklet / programme chart and uick reference card
supplied with the product are obtained in tests performed under controlled laboratory conditions and these tests are as
defined in relevant standards.
These figures may vary depending on how soiled the dishes are, the water hardness level
and other factors. Water inlet temperature, which is 13°C to 17°C in standard test conditions, is also an important variant
that may effect the figures.
** Reference programme for the Testing Institute and energy labeling. Testing program: Eco 50°C as compliant to EN
50242 international norms.
*** Due to continual improvement through research & design, specifications and design may change without prior notice
A+B
11,8
1,32
58
Wash
Cold rinse
Hot rinse
Drying
Lightly soiled dishes,
A class cleaning
in 58 minutes
3
ECO
50°C
4
QUICK & CLEAN
60°C
5
INTENSIVE
70°C
2
RAPID
35°C
1
PRE -WASH
No Heat
Cancel
P ess&Hold 3 sec.
On / Off Indicator Light
&
Progress Indicator Lights
Salt Level Indicator Light
Rinse Aid Level Indicator Light
Programme Starting Point
On/Off Button
Door Handle
Start / Sto Button
Programme Knob

Printed in Turkey Part no: 17 9775 01 00 Revision: AB-05/13
Beko plc, Beko House, Caxton Way, Watford, Hertfordshire, WD18 8UF
Tel : [phone] Fax : [phone] e-mail: [email protected] www.beko.co.uk
Operating the dishwasher
How to cancel the washing programme
Programme Sequence
·Turn the water tap on. Open the door of the machine.
·Check that the upper and lower arms can rotate freely.
·Pour (Put in) the detergent.
·Close the door of the machine.
·Push in the on/off button and check that the on/off indicator light comes on.
·Check the salt and rinse aid level indicator lights before you start the machine. If necessary
add salt and rinse aid.
·Select the re uired programme by referring to the programme chart.
·Select the desired programme by turning the selector knob.
·Press start / stop button and check that the wash indicator light comes on.
!Do not open the dishwasher door whilst the appliance is in operation. However, in case the
door is opened while the machine is working, then a safety mechanism ensures the machine
immediately stops. Water may be very hot, so be careful.
! Care must be taken if opening the door, as steam and water will escape.
·Press the on/off button after the programme is completed. The indicator light will go off.
·Unload the baskets - we recommend to turn off the water tap when not in use.
To cancel a programme while the machine is operating:
·Press and hold start/stop button for 3 seconds. The wash indicator light will start flashing.
The machine will drain the water inside the machine for 45 seconds.
·The programme is cancelled when wash indicator light goes off. Then, you can choose and
start a new programme.
!Depending on the stage of the programme you have cancelled, there may be detergent
residue or rinse aid inside the machine and on the load. Make sure the items in the dishwasher
are not used before washing properly.
To change the programme selection while the machine is operating:
·Press start/stop button. The wash indicator light will go off.
·Select the new programme. Press start/stop button. The wash indicator light will be on and
new programme will start.
!The new programme will NOT start right from the beginning. It will start from the stage last
carried out by the previous programme selection.
How to change the washing programme
While the dishwasher operates, "Wash" indicator light will be on. When the programme selected
is completed, "Wash" indicator light will go off Dry Indicator will come on. When drying finished
"End" indicator light will come on.
On / Off
On / Off Button
On / Off
Wash
D y
End
On/Off
indicator lig t
Progress
indicator lig ts
Sta t / Stop
Cancel
P ess&Hold 3 sec.
Start/Stop Button
Salt
Salt indicator lig t
Rinse Aid
Rinse-aid
indicator lig t