3 Installation
Refer to the nearest Authorized Service Agent
for installation of the product. To make the
product ready for use, make sure that the
electricity and water drainage system are
appropriate before calling the Authorized
Service Agent. If they are not, call a qualified
technician and plumber to have any necessary
arrangements carried out.
CPreparation of the product’s
location as well as the electrical
and waste water installations is
under customer’s responsibility.
BInstallation and electrical
connections of the product must
be carried out by the Authorized
Service Agent. Manufacturer shall
not be held liable for damages
that may arise from procedures
carried out by unauthorized
persons.
A
Prior to installation, visually check
if the product has any defects on
it. If so, do not have it installed.
Damaged products cause risks for
your safety.
ALet your dryer wait for 12 hours
before starting to use it.
3.1 Appropriate installation
location
• Install the product on a stable and level
surface.
• Dryer is heavy. Do not move it by yourself.
• Operate your product in a well ventilated,
dust-free environment.
• Do not block the air ducts in front of and
under the product with materials such as
long pile rugs, wooden blocks and bands.
• Do not install the product behind a door
with a lock, sliding door or a hinged door
which can strike the product.
• Once the product is installed, it should
stay at the same place where its
connections have been made. When
installing the product, make sure that the
rear wall of it does not touch anywhere
(tap, socket, etc.). Also pay attention to
select an installation location which you
will not be required to change afterwards.
• Place the product at least 1.5 cm away
from the edges of other furniture.
• The rear surface of the tumble dryer shall
be placed against a wall
BDo not place the product on the
power cable.
3.2 Removing the
transportation safety assembly
ARemove the transportation
safety assembly before using the
product for the first time.
1. Open the loadng door.
2. There s a nylon bag nsde the drum that
contans a pece of styrofoam. Hold t
from ts secton marked wth XX XX.
3. Pull the nylon towards yourself and
remove the transportaton safety
assembly.
AMake sure that no part of the
transportation safety assembly
remains inside the drum.
3.3 Under counter installation
• This product can be installed under a
counter if the height of the counter is suf-
cient.
AWhile using undercounter dryer,
it should never be operated
without undercounter installation
part.
Dryer Depth 60 cm 54 cm
Stock number of
under-bench
installation part 2979700100 2973600100
• Leave at least 3 cm of space around the
sides and the rear wall of the product
when installing it under a counter or in a
cupboard.