
Instructions for safety and environment
4 / 39 EN Refrigerator / User Manual
ker, etc.) which conforms to the electri-
cal regulations and disconnects all poles
from the grid.
tDo not touch the power plug with wet
hands.
tRemove the plug from the socket by
gripping the plug and not the cable.
A1.4 -
Transportation safety
tProduct is heavy; do not move it alone.
tDo not hold its door when moving the
product.
tPay attention not to damage the coo-
ling system or the piping during trans-
portation. If the piping is damaged, do
not operate the product and call the
authorised service agent.
A1.5 - Installation
safety
tCall the authorised service agent for
installation of the product. To make
the product ready for use, check the
information in the user manual to make
sure that the electricity and water ins-
tallations are suitable. If they are not,
call a qualified electrician and plumber
to have the necessary arrangements
made. Otherwise, there is the risk of
electric shock, fire, problems with the
product, or injury!
tPrior to installation, check if the product
has any defects on it. If the product is
damaged, do not have it installed.
tPlace the product on a clean, flat and
solid surface and balance it with adjus-
table feet. Otherwise, the product may
tip over and cause injuries.
tThe installation location must be dry
and well ventilated. Do not place car-
pets, rugs or similar covers under the
product. Insufficient ventilation causes
the risk of fire!
tDo not cover or block the ventilation
openings. Otherwise, power consumpti-
on increases and your product may get
damaged.
tProduct must not be connected to supply
systems such as solar power supplies.
Otherwise, your product may get dama-
ged due to sudden voltage changes!
tThe more refrigerant a refrigerator con-
tains, the larger the installation location
must be. If the installation location is
too small, flammable refrigerant and air
mixture will accumulate in cases of refri-
gerant leakage in cooling system. The re-
quired space for each 8 gr of refrigerant is
1 m3minimum. The amount of refrigerant
in your product is indicated on the Type
Label.
tProduct must not be installed in places
exposed to direct sunlight and it must
be kept away from heat sources such as
hobs, radiators, etc.
If it is inevitable to install the product close
to a heat source, a suitable insulation plate
must be used in between and the following
minimum distances must be kept to the heat
source:
- Minimum 30 cm away from heat sources
such as hobs, ovens, heater units or stoves,
- Minimum 5 cm away from electric ovens.
tProtection class of your product is Type
I. Plug the product in a grounded socket
that conforms the voltage, current and
frequency values stated on the type label
of the product. The socket must be equ-
ipped with a 10 A – 16 A circuit breaker.
Our company shall not be liable for any
damages that will arise when the product
is used without grounding and electrical
connection in accordance with the local
and national regulations.
tProduct must not be plugged in during
installation. Otherwise, there is the risk of
electric shock and injury!
tDo not plug the product in sockets that
are loose, dislocated, broken, dirty, greasy
or bear the risk of getting in contact with
water.
tRoute the power cable and hoses (if any)
of the product in a way that they do not
cause risk of tripping over.