
1. Place the massage mat on the floor.
2. Secure the cushion pad (1) to the massage mat using the hook and
loop fastener.
3. Insert the unit into the wall socket.
4. Lie on the massage mat so that the air cushion pads (4,6,7) are
located under the shoulders, the waist and the buttocks.
5. On the controller press the On/Off button (10). The lamp above the
button lights up.
6. Set to desired program by pressing the buttons.
- Stretch program (11): Gentle full body massage to
stretch all areas of the body slowly and gently.
– Mobilizes program (12): The whole body is massaged
and loosened with strong, invigorating power strokes.
- Relax program (14): Movements, based on simple yoga
exercises, that help to gentlyloosen and relax the body.
– Loosen program (15): Short program, ideally after
stressful days, helps to ease slight tensions with short,
moderate movements.
Cleaning and Storage
Do not use any sharp or abrasive cleaning agents or cleaning pads to
clean the device.These could damage the surfaces.
1. Make sure that the device is not connected to the main power.
2. Wipe down the mat with a slightly damp cloth. More intense soiling
can be removed with a mild detergent.
3. The device can be rolled up to make it easier to store or transport in
a confined space. It can easily be closed up using the zip fastener (1).
Remove the cushion pad (3) from the massage mat prior to rolling it up.
4. Keep the device and the plug adapter out of the reach of children
and animals in a dry, frost-free place that is protected from the sun.
Please note!
65
7. The intensity of the individual massage zones can be selected by
pressing the buttons [15, 16 or 17] . We recommend starting off with
intensity level 1 and slowly increasing the intensity.
NOTE: When there is a change of program, the medium intensity level
is always selected automatically.
Remain lying on the massage mat for the time you want. We
recommend that you use each massage program for no more than 20
minutes.
8. Switch off the device using the On/Off button.
9. Pull the plug adapter out of the plug socket and disconnect the
barrel connector from the device.
How to Use
The device must not be folded up or covered when it is switched on.
Do not place the mains cable or the controller on or beneath the
device during operation.
Please note!