BEMMA Terra User manual

P.9-11
ASSEMBLY INSTRUCTIONS
TERRA ASSEMBLY INSTRUCTIONS
Designer Vanities & Accessories

BEFORE
You Begin
1. Tools and materials needed:
2. Product dimensions:
3. Damaged product: DO NOT USE if product and/or components
are broken
4. For installation of faucet and plumbing, we recommend the use
of a licensed plumber. Ensure all building & plumbing codes are
respected
5. Assembly should be done with two adults
ASSEMBLY INSTRUCTIONS
Marker Drill Phillips
Screwdriver
Tape
Measure
Stud
Finder Level

STEP 1
Prepare for Installation
ASSEMBLY INSTRUCTIONS
1. Using the stud finder and marker, locate and mark the studs
behind the wall
Important: if the studs do not line up for your vanity, wood blocking
can be installed between studs
2. Draw two horizontal lines on wall using level at 30.75” and 25.25”
from floor
Important: before drilling wall, ensure existing electrical wires or
plumbing is not in the way of any drilling
3. Line cleat holes with wall line and ensure cleat is level. Screwing
directly into studs will give the most strength
4. Using supplied wood screws (Part C) and anchors, screw horizontal
wood mounting cleats (Part A) onto wall
wall board wood framing
drill both wood cleats
into studs for best
mounting strength
mount cleats (2) to wall
at 30.75” and 25.25”
height from floor,
to achieve standard
34” vanity height
30.75
25.25
34.0

STEP 2
Secure Vanity to Wall
ASSEMBLY INSTRUCTIONS
1. With two adults, carefully lift vanity onto the wall cleats, mating
with Cleat B and resting flush against the wall
2. Check installation with level
3. Install plumbing (we recommend the use of a licensed plumber)
4. Apply silicone to the sides and back edge of the top
5. Wipe away any excess silicone immediately
6. Allow silicone sealant to fully dry for 24 hours
carefully lift vanity onto wall cleats,
mating with Cleat B (Part B)

STEP 3
Adjust the Glides (if required)
ASSEMBLY INSTRUCTIONS
1. If vanity drawers are misaligned, adjust glides
Height adjustment
Located at the
bottom of the drawer

STEP 4
Removing Drawer (if required)
1. Pull out the slide lock which is located at the bottom of the drawer
2. Lift drawer box up from the peg
3. Pull the drawer box out of the back hook and gently lift out
ASSEMBLY INSTRUCTIONS

STEP 5
Inserting Drawer (if required)
1. Pull drawer glides all the way out
2. Locate the 3 holes on the drawer box
3. Insert the drawer box into the back hook
4. Gently place drawer box onto the peg
5. Push in the bottom of the lock which is located at the bottom
of the drawer
6. Adjust the slides as seen in step 3 (if needed)
ASSEMBLY INSTRUCTIONS
3
2
1

TERRA
Product Details
CARE AND CLEANING
For stone tops such as marble and granite, it is recommended that you apply a high-
quality sealer to protect from staining and discoloration. Stone sealer should be
reapplied once or twice per year, depending on usage.
After each use, simply wipe with a soft cloth to remove any surface dirt.
For standard cleaning, we recommend using warm water with vinegar.
DO NOT USE abrasive products or cream cleansers.
NEVER USE petroleum-based products when cleaning, i.e. paint thinners or other
solvents, as they may damage the wood
THANK YOU FOR YOUR BEMMA PURCHASE
ASSEMBLY INSTRUCTIONS