BENIFERRO ZVZX1010-P User manual

Quick Start Guide
EPDM Solar heating panels
ZVZX1010-P, ZVZX1210-P, ZVZX1220-P, ZVZX1230-P, ZVZX1240-P

2
General comments
Consult the full user manual on https://beniferro.eu/solar-heating/epdm-solar-heating-kit/:
Strickly follow all safety measures described in this quick start manual and in the full user
manual.
Unpacking
When opening the box, take care not to cut into the EPDM solar heating.
The box will contain :
3 pre-assembled EPDM heaters (length 2,3,4,5 or 6 meter) fittere with a collector at each end.
6 O-rings
10 ty-rips
2 conectors 50-38-32 mm
2 closed collector ends
Installation
1Put the 3 heating mats next to each other. Put the O-ring around each collector end and around
the 2 closed collector ends.
2Click the collectors into each other, and put the ty-rips through the collector
3Cut the conectors 50-38-38 to the desired size using a metal saw. In case of 50mm cut the
conector at the spot indicated on the right drawing.
4Put the EPDM collectors at the desired place. This can be a roof, the floor etc … . Make sure no
sharp objects can pierce the collectors. Fix the collectors to the underground using webbing
strap or special silicones all available from your dealer.
When placing the mats on a roof, take all necessary safety precautions to work safely.

3
5Connect the EPDM mat inlet and outlet. In case of using 50mm PVC, use PVC glue. The ideal
location of the EPDM mats is just after the filter, before the heatpump. In all cases, the water
treatment has to be done after the heating mats, never before. We recommend to use a
(automated) 3-way valve to bypass the solar heating in case the roof temperature is colder than
the pool water temperature. See the connection scheme.
Safety Precautions
Do not put the EPDM heating in a environment higher than 60 degC
Do not pressure higher than 1.5 bar on the EPDM heating
Do not circulate water with pH lower than 7.2 or higher than 7.6 through the heating mats.
Do not ciruclate water with free chlorine content higher than 1ppm over the heating mats.
Do not walk over the collectors
Use appropriate safety precautions / equipment when working in height
Winterizing
Empty the collectors before winter. EPDM rubber will not freeze, the collectors will freeze when left full
with water.
Temp
Temp

4
Repairs
Repairs can be done easily:
-Collectors can be put on the EPDM using soap or by soaking the EPDM 10 minutes in gasoline.
The EPDM will swell, and later unswell.
-Holes in the EPDM can be repaired with our repail nipples, available via your dealer
-Visit the website Beniferro.eu for detailed repair instructions
More info can be found in the complete manual.
READ THE COMPLETE MANUAL AVAILABLE AT : WWW.BENIFERRO.EU
COMPLETE MANUAL :
https://beniferro.eu/solar-heating/epdm-solar-heating-kit/?preview_id=670&preview_nonce=45d4d0971e&preview=true