Bentz Jaz FLYght Duo User manual

PROBLEM
SOLUTION
LED diodes are
flickering
Be sure the unit is
grounded properly.
Replace LED light
stick.
LED diodes do
not light
Replace the LED
light stick.
Trap stops working
after a few days
Inspect the cord
connection to the
light trap and
electrical outlet.
Disconnect and
contact Bentz Jaz
Customer Service
SAFETY PRECAUTIONS
Inspect light trap for any damage that
may have occurred during shipping.
Connect light trap only to120V 60Hz
electrical supply.
This light trap is only for indoor use,
do not expose to water or excess
humidity.
Use a grounded extension cord, with
3 terminals; always use an electric
outlet that is properly grounded.
OPERATION
•BioVE board should be replaced at
least 1 time per year. For best
results keep the BioVE light board
clean.
BioVE board can be slightly bent in
the middle to insert into the top and
bottom slots on the back panel of the
light trap.
Glue boards should be replaced
when 60% of the surface is covered
with insects.
Disconnect electrical power before
cleaning the unit.
Wipe the outside of the trap to keep
the opening clean and dust free.
TRAP USE AND
PLACEMENT
Installation can be made in
residential and commercial kitchens,
food preparation areas, food storage
rooms, and the dining areas.
Position trap away from direct
sunlight.
Position traps to allow for changing
glue boards.
Position traps so that it is visible from
all areas of room, especially doors
that open to the outside.
TRAP INSTALLATION
Select a position with access to a
3-pole electrical outlet. Alterations
of the electrical cord must be
performed by qualified personnel.
Do not place units where they will
be exposed to water during
normal operation or during routine
cleaning activity of the location.
Follow the diagram for placing the
wall anchor screws necessary for
attaching the unit to a wall.
Trap weighs 5 lbs. Place on a wall
that can support this weight.
FLYght Duo Insect Light Trap - User’s Manual
HAVING PROBLEMS?
Call the Bentz Jaz USA
Help Line:
470-379-4371
FLYght Duo
Bentz Jaz USA
4200 Industrial Center Lane
Suite 100
Ackworth GA 30101

FLYght Duo Insect Light Trap – Care and Maintenance
Glue board edges
do not have glue
to inserting and
removing easy.
GLUE BOARDS
Insert glue board
face down in
groove.
Insert top
glue board
behind the
clip.
bioVE BOARD
Replace bioVE
board when dirty
or damaged, and
after 1 year use.
Insert new bioVE
board with the
logo facing the
front.
Bend the bioVE
board along the
crease on back to
fold and insert.
LED Stick
Replace the LED
Stick when one or
more of the lights
are not shining.
Insert the connector into the
end of the new LED Stick.
The ends of the
LED Sticks have a
button that snaps
into a bracket.
The ends of the
LED Sticks must
be securely
snapped into the
bracket.
LED Stick
bracket.
UNLIMITED 1-YEAR WARRENTY
To the original purchaser of a new Bentz Jaz USA FLYght Duo light trap with
proof of purchase and purchase date, Bentz Jaz USA warrants replacement
or repair free of charge the FLYght Duo light traps deemed by Bentz Jaz USA
to be faulty. Replacement or repair of defective parts shall constitute the sole
and exclusive remedy of the original purchaser. In no event shall Bentz Jaz
USA be liable for any special, consequential, or incidental damages, nor for
damage due to accident, abuse, lack of reasonable care, normal wear,
unauthorized repair or operation on a power source other than 120V, 60HZ.