Bert Frank RIDDLE SINGLE User manual

2
- Turn the thumb screw on the side of the knuckle joint
to adjust the angle of the shade up or down as desired.
- This shade does not twist.
RIDDLE SINGLE
FLOOR LAMP
- Lacquered brass shade should be wiped with a soft duster.
- Coloured parts can be wiped with a damp cloth
(unplug from mains first).
- 1 x G9 LED bulbs
www.bertfrank.co.uk
[phone]
INSTALLATION
MAINTENANCE
TECHNICAL
1
4
3- The arm of the lamp does not move vertically. It does
rotate.
- To adjust rotation angle firstly loosen the tightening blocks.
- Ensure that the arm of the light is supported as
this is carried out.
- Position the base at the end of the stem and secure
by inserting the Hex bolt through the base into the stem.
- Tighten securely with provided Alan Key.
- Gently lying the lamp stem and arm on a soft surface,
unscrew hex bolt from end of stem with Alan
Key provided.
!! !!
Be sure not
to over loosen.

21
BULB REPLACEMENT
- Replace G9 bulb by pushing them into lamp holder.
This product is only suitable for connection to the native power supply to which the unit was specifically manufactured. It is for indoor
use only, and not suitable for a bathroom location.
If the Class II, double insulated symbol is on the lamp, it does not require an Earth, and Live or Neutral must not be connected to Earth.
If there is no such symbol, then the lamp must be Earthed.
Under no circumstances must this floor lamp be covered with any material as this could pose a safety hazard. It must be used on a
stable, flat surface.
Never fit bulbs of a higher wattage than those specified on the label, as these may cause overheating and damage the fitting.
If the mains cable becomes damaged it must only be replaced by a technically competent, qualified person.
Allow 10 minutes to cool before replacing, adjusting or cleaning. Clean with a dry cloth only. Do not use liquid or abrasive cleaners on
this product.
If you are in any doubt about your competence please consult a qualified electrician. If any modification is made it will invalidate the
warranty and may render the product unsafe.