Bertini BR1501-1 User manual

www.bertinibaby.com
INSTRUCTION MANUAL
Model No:
NOTE:
BR1501-1
THIS INSTRUCTION BOOKLET
CONTAINS IMPORTANT SAFETY
UPC CODE:
0-65857-17100-6
AUBURN 6 DRAWER
DRESSER
INFORMATION. PLEASE READ AND
KEEP FOR FUTURE REFERENCE.
_______ / _______ / _______
(TAKEN FROM CARTON)
Date of purchase:
Lot number:
____________________________________
NEED HELP!
CALL US FOR ASSISTANCE
1-800-295-1980
DO NOT RETURN PRODUCT TO STORE
E-MAIL:[e-mail]
Contact Customer Service with
any questions.
1-800-295-1980
[email protected]
Fax #: [phone]

*
*
*
* Handling will require two people.
LIMITED WARRANTY
Dorel warrants its product to be free from defects in material and workmanship
and agrees to remedy any such defect. This warranty covers 1 year from the
date of original purchase. This warranty is valid only upon presentation of proof
of purchase. This is solely limited to the repair or replacement of defective
furniture components and no assembly labor is included. This warranty does
not apply to any product which has been improperly assembled, subjected to
misuse or abuse or which has been altered or repaired in any way. This
warranty gives you specific legal rights and you may also have other rights
which vary from State to State.
WARNING: Should this product become damaged,
and/or components are broken or missing, DO NOT USE.
Do not use the unit if it is damaged or broken.
CARE AND CLEANING
Dust regularly with a soft, lint-free cloth to prevent soil build-up. A damp cloth
may be used occasionally to clean surface. Dry immediately. Do not use any
abrasives that may damage finish. Excessive exposure to sunlight and extreme
changes in temperature and moisture can damage wood furniture.
MAINTENANCE
Check bolts/screws periodically and tighten them if necessary.
Montreal, Quebec
Canada H1G 3L1
E-MAIL: d[email protected]
NOTES:
Read all instructions before use.
Keep instructions for future use.
CUSTOMER SERVICE
If you have any questions about this product, contact our customer
service representative first!
CALL 1-800-295-1980
Customer Service Department No. 413
12345 Albert-Hudon Boulevard, Suite 100

PARTS LIST
NO. Drawing Q'ty
A 2 PCS
B 4 PCS
C 1 Kit
Large Lower Drawer
AUBURN 6 DRAWER DRESSER
BR1501-1
Description
Small Top Drawer
Safety Strap Kit

AUBURN 6 DRAWER DRESSER
BR1501-1
CAUTION: This unit is intended for use only with
the products and/or maximum weights indicated. Use
with other products and/or products heavier than the
maximum weights indicated may result in instability or
cause possible injury.
MAXIMUM WEIGHT
FOR SMALL TOP
DRAWERS - 15 LBS
MAXIMUM WEIGHT
FOR TOP - 25 LBS
MAXIMUM WEIGHT FOR
LARGE LOWER DRAWERS -
15 LBS
Contact Customer Service with
any questions.
1-800-295-1980
[email protected]
Fax #: [phone]
NEED HELP!
CALL US FOR ASSISTANCE
1-800-295-1980
DO NOT RETURN PRODUCT TO STORE
E-MAIL:[e-mail]

Furniture Wall Safety Strap
Hardware List
SAFETY WALL STRAP 1 PC
TOOLS NECESSARY: RUBBER MALLET AND PHILLIPS SCREW DRIVER ARE NOT INCLUDED.
NOTE: 5/16" DRILL BIT AND ELECTRIC DRILL ARE NOT PROVIDED.
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE
USING THIS PRODUCT AND KEEP THESE INSTRUCTIONS FOR
FUTURE REFERENCE. IF YOU HAVE ANY QUESTIONS, PLEASE
CALL OUR CUSTOMER SERVICE NUMBER: [phone].
TO MOVE THE FURNITURE AFTER THE SAFETY WALL STRAP HAS BEEN INSTALLED, SIMPLY
REMOVE THE SCREW (PART A) FROM THE WALL TO LOOSEN THE SAFETY WALL STRAP.
STEP 2: USING A RUBBER MALLET, HAMMER THE WALL
ANCHOR (PART D) INTO THE DRILLED HOLE UNTIL THE
OPENING OF THE WALL ANCHOR (PART D) IS EVEN WITH THE
WALL.
STEP 3: MAKE A MARK ON THE BACK FRAME OF THE
FURNITURE (AT THE MIDDLE POSITION OF THE TOP PANEL
BACKSIDE, WHERE YOU WOULD LIKE TO INSTALL THE
SAFETY WALL STRAP). INSERT THE SHORT SCREW (PART C)
AND THE SAFETY WALL STRAP (E) INTO THE METAL
BRACKET (PART B), THEN INSTALL IT INTO WHERE THE
MARK WAS MADE WITH A PHILLIPS SCREW-DRIVER,AS
SHOWN IN RIGHT SIDE.
STEP 4: TO INSTALL THE SAFETY WALL STRAP (E) TO THE
WALL, INSERT THE LONG SCREW (PART A) AND THE SAFETY
WALL STRAP (PART E) THROUGH THE METAL BRACKET
(PART B) AND SECURE THE SCREW (PART A) INTO THE WALL
ANCHOR (PART D) USING THE PHILLIPS SCREW DRIVER. AND
THEN PUT THE TAIL OF SAFETY WALL STRAP (E) TO THE
HOLE OF SAFETY WALL STRAP (E) HEAD, PULL IT FOR
TIGHTEN THE STRAP.
LONG SCREW 1 PC
METAL BRACKET 2 PCS
SHORT SCREW 1 PC
WARNING: WHEN UPRIGHT, IT IS POSSIBLE THAT THE
FURNITURE MAY TIP OVER. PLEASE INSTALL THE SAFETY WALL
STRAP BEHIND THE FURNITURE TO ENSURE SAFETY.
STEP 1: LOCATE AND MARK A SPOT ON THE WALL BEHIND
THE FURNITURE (ABOUT 2" to 3" BELOW THE TOP OF THE
FURNITURE), AND SLIDE THE FURNITURE AWAY FROM THE
WALL, ALLOWING YOURSELF ENOUGH ROOM TO WORK.
USING A 5/16" DRILL BIT, DRILL A HOLE, (ABOUT 1-1/4" DEEP)
AT WHERE THE MARK IS LOCATED.
C B DEAB B
A
B
C
HOLE
D
A
C
B
B
D

MODEL #: BR1501-1
PLEASE CONTACT CUSTOMER SERVICE REPRESENTATIVES AT THE FOLLOWING
NUMBERS SHOULD YOU HAVE ANY QUESTIONS.
Request Date:
Name:
Shipping Address:
Street & Number:
City & State:
Zip Code:
Day Time Phone Number:
(including area code)
Date & Place of Purchase:
Part(s) description and quantity: (Please be sure to list model number or SKN number)
Customer Service Representative Mailing Address:
Customer Service Department No. 413, 12345 Albert-Hudon Boulevard, Suite 100, Montreal, QC, Canada, H1G 3L1
Customer Service
Customer Service Phone Number 1-800-295-1980
Email: [email protected]
Customer Service Fax Number 514-353-7819
PLEASE DO NOT RETURN THIS PRODUCT TO THE STORE