Package contents
• Refrigerator water lter
• Quick Setup Guide
Compatibility
Compatible with the following
branded lters:
LG®
LT800P, LT800PC, LT800PCS,
ADQ73613401, ADQ73613401-S,
ADQ73613402, ADQ73613402-S,
ADQ73613403, ADQ73613407,
ADQ32617801, ADQ32617703,
ADQ72910901,ADQ73613408,
ADQ75795104
Kenmore®
9490, 469490, 46-9490
Features
• NSF 42 and 53 certied to lter contaminants, including chlorine, cysts, lead,
mercury, carbofuran, benzene, and endrin
• Lasts up to six months or 200 gallons (757 L)
• Eliminates cloudiness for fresh, clear drinking water
Installing your water lter
• It is normal for black carbon particles to appear on the outside of your lter. This
happens when the lter is moved during shipping. It is safe, simply wipe them o.
1Shut o the water supply, then turn o the water shuto valve on your
refrigerator.
2Locate the lter holder in the back upper right-hand corner of the refrigerator. To
open the lter cover, push in where indicated and the cover will drop down.
3Remove the old lter by slowly rotating it counter-clockwise. A small amount of
water may drip down.
Note: When you pull out the water lter, a little water may leak from the opening. This is
normal. To minimize the water leakage, keep the lter horizontal when you pull it out.
4Insert the new lter into the water lter holder.
5Slowly turn the new lter clockwise until it stops. The lter will click and lock into
place.
Note: The lter connectors are large to prevent leaks. You might have to twist the lter hard
to make sure that the connection is secure.
6Close the lter cover.
7 Turn on the water supply and run water through the dispenser for about ve
minutes at 0.5 gpm (about 2.5 gallons or 9.5 L) to remove any trapped air and clear
the system.
CAUTION: This lter should not be used with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the system.
8Open the refrigerator door and make sure that no water leaks from the new lter.
Note: If leaks occur, repeat the installation steps. If leaks persist, discontinue use and call
customer service.
WARNING: To reduce the risk of property damage due to water leakage, this lter MUST be
installed in accordance with the manufacturer's specications and instructions. This lter unit
must be replaced every 200 gallons (757 L) or 6 months. Failure to follow instructions and
operating specications will void your warranty. Further, the manufacturer assumes no
responsibility or liability for damages arising out of misuse of the product.
Refrigerator
Filter
Quick Setup Guide
BE-LGLT800P531
Before using your new product, please read
these instructions to prevent any damage.
Resetting your change
lter indicator
• LG: Press and hold the reset button
for three seconds. If this doesn’t
work, see the documentation that
came with your refrigerator.
• Kenmore: The lter reset for
Kenmore refrigerators varies by
model. See the documentation that
came with your refrigerator.
Storage and maintenance
• Replace your lter every six months
or two hundred gallons (757 L) to
prevent bacteria and fungus growth
in your lter, supply lines, and
storage tank.
• Stored lters do not expire. Keep
your unused lters in a cool, dark,
and dry place until you need them.
• If you do not use your water
dispenser for more than four days,
run two gallons (7.6 L) of water
before using it to prevent bad
tasting water.
